[PATCH v14 10/15] bpf/rqspinlock: Use smp_cond_load_acquire_timeout()

Ankur Arora <[email protected]>
Newsgroups org.kernel.vger.linux-arch,org.infradead.lists.linux-arm-kernel,org.kernel.vger.bpf,org.kernel.vger.linux-kernel,org.kernel.vger.linux-pm
Message-ID <[email protected]>
Switch out the conditional load interfaces used by rqspinlock
to smp_cond_read_acquire_timeout() and its wrapper,
atomic_cond_read_acquire_timeout().

Both these handle the timeout and amortize as needed, so use the
non-amortized RES_CHECK_TIMEOUT.

RES_CHECK_TIMEOUT does double duty here -- presenting the current
clock value, the timeout/deadlock error from clock_deadlock() to
the cond-load and, returning the error value via ret.

For correctness, we need to ensure that the error case of the
cond-load interface always agrees with that in clock_deadlock().

For the most part, this is fine because there's no independent clock,
or double reads from the clock in cond-load -- either of which could
lead to its internal state going out of sync from that of
clock_deadlock().

There is, however, an edge case where clock_deadlock() checks for:

        if (time > ts->timeout_end)
                return -ETIMEDOUT;

while smp_cond_load_acquire_timeout() checks for:

        __time_now = (time_expr_ns);
        if (__time_now <= 0 || __time_now >= __time_end) {
                VAL = READ_ONCE(*__PTR);
                break;
        }

This runs into a problem when (__time_now == __time_end) since
clock_deadlock() does not treat it as a timeout condition but
the second clause in the conditional above does.
So, add an equality check in clock_deadlock().

Finally, redefine SMP_TIMEOUT_POLL_COUNT to be 16k to be similar to
the spin-count used in the amortized version. We only do this for
non-arm64 as that uses a waiting implementation.

Cc: [email protected]
Cc: Kumar Kartikeya Dwivedi <[email protected]>
Cc: Alexei Starovoitov <[email protected]>
Acked-by: Kumar Kartikeya Dwivedi <[email protected]>
Signed-off-by: Ankur Arora <[email protected]>
---
 kernel/bpf/rqspinlock.c | 40 +++++++++++++++++++++++-----------------
 1 file changed, 23 insertions(+), 17 deletions(-)

diff --git a/kernel/bpf/rqspinlock.c b/kernel/bpf/rqspinlock.c
index 0ec17ebb67c1..e5e27266b813 100644
--- a/kernel/bpf/rqspinlock.c
+++ b/kernel/bpf/rqspinlock.c
@@ -215,7 +215,7 @@ static noinline s64 clock_deadlock(rqspinlock_t *lock, u32 mask,
 	}
 
 	time = ktime_get_mono_fast_ns();
-	if (time > ts->timeout_end)
+	if (time >= ts->timeout_end)
 		return -ETIMEDOUT;
 
 	/*
@@ -235,11 +235,10 @@ static noinline s64 clock_deadlock(rqspinlock_t *lock, u32 mask,
 }
 
 /*
- * Do not amortize with spins when res_smp_cond_load_acquire is defined,
- * as the macro does internal amortization for us.
+ * Spin amortized version of RES_CHECK_TIMEOUT. Used when busy-waiting in
+ * atomic_try_cmpxchg().
  */
-#ifndef res_smp_cond_load_acquire
-#define RES_CHECK_TIMEOUT(ts, ret, mask)					\
+#define RES_CHECK_TIMEOUT_AMORTIZED(ts, ret, mask)				\
 	({									\
 		s64 __timeval_err = 0;						\
 		if (!(ts).spin++)						\
@@ -247,7 +246,7 @@ static noinline s64 clock_deadlock(rqspinlock_t *lock, u32 mask,
 		(ret) = __timeval_err < 0 ? __timeval_err : 0;			\
 		__timeval_err;							\
 	})
-#else
+
 #define RES_CHECK_TIMEOUT(ts, ret, mask)					\
 	({									\
 		s64 __timeval_err;						\
@@ -255,7 +254,6 @@ static noinline s64 clock_deadlock(rqspinlock_t *lock, u32 mask,
 		(ret) = __timeval_err < 0 ? __timeval_err : 0;			\
 		__timeval_err;							\
 	})
-#endif
 
 /*
  * Initialize the 'spin' member.
@@ -269,6 +267,17 @@ static noinline s64 clock_deadlock(rqspinlock_t *lock, u32 mask,
  */
 #define RES_RESET_TIMEOUT(ts, _duration) ({ (ts).timeout_end = 0; (ts).duration = _duration; })
 
+/*
+ * Limit how often we invoke clock_deadlock() while spin-waiting in
+ * smp_cond_load_acquire_timeout() or atomic_cond_read_acquire_timeout().
+ *
+ * We only override the default value not superceding ARM64's override.
+ */
+#ifndef CONFIG_ARM64
+#undef SMP_TIMEOUT_POLL_COUNT
+#define SMP_TIMEOUT_POLL_COUNT	(16*1024)
+#endif
+
 /*
  * Provide a test-and-set fallback for cases when queued spin lock support is
  * absent from the architecture.
@@ -296,7 +305,7 @@ int __lockfunc resilient_tas_spin_lock(rqspinlock_t *lock)
 	val = atomic_read(&lock->val);
 
 	if (val || !atomic_try_cmpxchg(&lock->val, &val, 1)) {
-		if (RES_CHECK_TIMEOUT(ts, ret, ~0u) < 0)
+		if (RES_CHECK_TIMEOUT_AMORTIZED(ts, ret, ~0u) < 0)
 			goto out;
 		cpu_relax();
 		goto retry;
@@ -319,12 +328,6 @@ EXPORT_SYMBOL_GPL(resilient_tas_spin_lock);
  */
 static DEFINE_PER_CPU_ALIGNED(struct qnode, rqnodes[_Q_MAX_NODES]);
 
-#ifndef res_smp_cond_load_acquire
-#define res_smp_cond_load_acquire(v, c) smp_cond_load_acquire(v, c)
-#endif
-
-#define res_atomic_cond_read_acquire(v, c) res_smp_cond_load_acquire(&(v)->counter, (c))
-
 /**
  * resilient_queued_spin_lock_slowpath - acquire the queued spinlock
  * @lock: Pointer to queued spinlock structure
@@ -421,7 +424,9 @@ int __lockfunc resilient_queued_spin_lock_slowpath(rqspinlock_t *lock, u32 val)
 	 */
 	if (val & _Q_LOCKED_MASK) {
 		RES_RESET_TIMEOUT(ts, RES_DEF_TIMEOUT);
-		res_smp_cond_load_acquire(&lock->locked, !VAL || RES_CHECK_TIMEOUT(ts, ret, _Q_LOCKED_MASK) < 0);
+		smp_cond_load_acquire_timeout(&lock->locked, !VAL,
+					      RES_CHECK_TIMEOUT(ts, ret, _Q_LOCKED_MASK),
+					      ts.duration);
 	}
 
 	if (ret) {
@@ -582,8 +587,9 @@ int __lockfunc resilient_queued_spin_lock_slowpath(rqspinlock_t *lock, u32 val)
 	 * us.
 	 */
 	RES_RESET_TIMEOUT(ts, RES_DEF_TIMEOUT * 2);
-	val = res_atomic_cond_read_acquire(&lock->val, !(VAL & _Q_LOCKED_PENDING_MASK) ||
-					   RES_CHECK_TIMEOUT(ts, ret, _Q_LOCKED_PENDING_MASK) < 0);
+	val = atomic_cond_read_acquire_timeout(&lock->val, !(VAL & _Q_LOCKED_PENDING_MASK),
+					       RES_CHECK_TIMEOUT(ts, ret, _Q_LOCKED_PENDING_MASK),
+					       ts.duration);
 
 	/* Disable queue destruction when we detect deadlocks. */
 	if (ret == -EDEADLK) {
-- 
2.43.7
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.