[PATCH v5 2/4] arm64: dts: qcom: pm8005: Add temp alarm node

Add temperature alarm node along with thermal zone used
for PMIC thermal mitigation.

Co-developed-by: Rakesh Kota <[email protected]>
Signed-off-by: Rakesh Kota <[email protected]>
Reviewed-by: Konrad Dybcio <[email protected]>
Signed-off-by: Jishnu Prakash <[email protected]>
---
 arch/arm64/boot/dts/qcom/pm8005.dtsi | 35 +++++++++++++++++++++++++++++++++++
 1 file changed, 35 insertions(+)

diff --git a/arch/arm64/boot/dts/qcom/pm8005.dtsi b/arch/arm64/boot/dts/qcom/pm8005.dtsi
index 0f0ab2da8305..ce31a8545020 100644
--- a/arch/arm64/boot/dts/qcom/pm8005.dtsi
+++ b/arch/arm64/boot/dts/qcom/pm8005.dtsi
@@ -4,6 +4,34 @@
 #include <dt-bindings/spmi/spmi.h>
 #include <dt-bindings/interrupt-controller/irq.h>
 
+/ {
+	thermal-zones {
+		pm8005-thermal {
+			thermal-sensors = <&pm8005_tz>;
+
+			trips {
+				pm8005_trip0: trip0 {
+					temperature = <105000>;
+					hysteresis = <0>;
+					type = "passive";
+				};
+
+				pm8005_trip1: trip1 {
+					temperature = <125000>;
+					hysteresis = <0>;
+					type = "hot";
+				};
+
+				pm8005_trip2: trip2 {
+					temperature = <145000>;
+					hysteresis = <0>;
+					type = "critical";
+				};
+			};
+		};
+	};
+};
+
 &spmi_bus {
 	pm8005_lsid0: pmic@4 {
 		compatible = "qcom,pm8005", "qcom,spmi-pmic";
@@ -11,6 +39,13 @@ pm8005_lsid0: pmic@4 {
 		#address-cells = <1>;
 		#size-cells = <0>;
 
+		pm8005_tz: temp-alarm@2400 {
+			compatible = "qcom,spmi-temp-alarm";
+			reg = <0x2400>;
+			interrupts = <0x4 0x24 0x0 IRQ_TYPE_EDGE_BOTH>;
+			#thermal-sensor-cells = <0>;
+		};
+
 		pm8005_gpios: gpio@c000 {
 			compatible = "qcom,pm8005-gpio", "qcom,spmi-gpio";
 			reg = <0xc000>;

-- 
2.43.0