Re: [PATCH 3/4] arm64: dts: qcom: Add Retroid Pocket 6
Konrad Dybcio <[email protected]>
| Newsgroups | org.kernel.vger.linux-arm-msm,org.kernel.vger.linux-devicetree,org.kernel.vger.linux-kernel |
|---|---|
| Message-ID | <[email protected]> |
On 8/8/26 7:37 PM, Aaron Kling via B4 Relay wrote: > From: Aaron Kling <[email protected]> > > The Retroid Pocket 6 is a high-performance Android-based handheld gaming > console powered by the Qualcomm Snapdragon 8 Gen 2 processor featuring a > 5.5-inch AMOLED touchscreen. [...] > +&{/} { > + model = "Retroid Pocket 6"; > + compatible = "retroidpocket,rp6", "qcom,qcs8550", "qcom,sm8550"; > + > + backlight: backlight { > + compatible = "pwm-backlight"; > + pwms = <&pmk8550_pwm 0 860000>; > + brightness-levels = <1023 0>; > + num-interpolated-steps = <1023>; > + default-brightness-level = <600>; > + power-supply = <&vph_pwr>; > + enable-gpios = <&pmk8550_gpios 5 GPIO_ACTIVE_HIGH>; > + pinctrl-names = "default"; > + pinctrl-0 = <&pwm_backlight_default>; property-n property-names in this order please > +&i2c_hub_3 { > + clock-frequency = <100000>; > + > + status = "okay"; > + > + touchscreen@38 { > + compatible = "focaltech,ft5426"; > + reg = <0x38>; > + > + interrupt-parent = <&tlmm>; > + interrupts = <15 IRQ_TYPE_EDGE_FALLING>; > + reset-gpios = <&tlmm 14 GPIO_ACTIVE_LOW>; > + > + vcc-supply = <&ts_avdd_3v0>; > + iovcc-supply = <&ts_vddio_1v8>; > + > + pinctrl-0 = <&ts_p_rst_default &ts_p_int_default>; <&foo>, <&bar> preferably (dtc treats it all the same unforunately..) otherwise largely lgtm Konrad