[PATCH] floppy: flush pending work before releasing resources on init failure

do_floppy_init() probes each FDC with user_reset_fdc(), which queues a
redo_fd_request() work item on floppy_wq that may still be pending when
the probe finishes. When no controller is found, the error path calls
floppy_release_irq_and_dma() to free the IRQ and DMA channel, and only
later destroys the workqueue. destroy_workqueue() drains the queued work
last, so it can run after the IRQ and DMA are already gone:

  floppy0: no floppy controllers found
  work still pending

The flush used to be here. Commit 070ad7e793dc ("floppy: convert to
delayed work and single-thread wq") renamed the label out_flush_work to
out_release_dma and dropped it. Restore it so the work drains before the
IRQ and DMA are released, as floppy_module_exit() already does.

Fixes: 070ad7e793dc ("floppy: convert to delayed work and single-thread wq")
Assisted-by: Claude:claude-opus-4-8
Signed-off-by: Karl Mehltretter <[email protected]>
---

Noticed while running mainline on an emulated Acorn RiscPC, a custom
personal QEMU machine. It has no floppy controller and rpc_defconfig
sets CONFIG_BLK_DEV_FD=y, so every boot takes the no-controller error
path. No disk is registered there, so the drained work takes the
empty-request fast path and just unlocks the FDC, leaving only the
spurious message.

Verified with 100 QEMU boots per platform on v7.2-rc4, no controller
present. "work still pending" appeared on an unfixed kernel vs with this
patch:

  Acorn RiscPC, rpc_defconfig: 100/100 -> 0/100
  x86_64 defconfig, qemu -M q35: 6/100 -> 0/100

With a controller present on qemu -M pc, reading and writing a 1.44M
floppy image still works.

 drivers/block/floppy.c | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/drivers/block/floppy.c b/drivers/block/floppy.c
index f04397b8e381..6cfd114d27df 100644
--- a/drivers/block/floppy.c
+++ b/drivers/block/floppy.c
@@ -4744,6 +4744,8 @@ static int __init do_floppy_init(void)
 		}
 	}
 out_release_dma:
+	/* Drain the queued redo_fd_request() before releasing IRQ and DMA. */
+	flush_workqueue(floppy_wq);
 	if (atomic_read(&usage_count))
 		floppy_release_irq_and_dma();
 out_unreg_driver:
-- 
2.53.0