Re: [PATCH] floppy: flush pending work before releasing resources on init failure

Hello,

Thank you for the patch.

On 22/07/2026 07:44, Karl Mehltretter wrote:
> do_floppy_init() probes each FDC with user_reset_fdc(), which queues a
> redo_fd_request() work item on floppy_wq that may still be pending when
> the probe finishes. When no controller is found, the error path calls
> floppy_release_irq_and_dma() to free the IRQ and DMA channel, and only
> later destroys the workqueue. destroy_workqueue() drains the queued work
> last, so it can run after the IRQ and DMA are already gone:
> 
>   floppy0: no floppy controllers found
>   work still pending
> 
> The flush used to be here. Commit 070ad7e793dc ("floppy: convert to
> delayed work and single-thread wq") renamed the label out_flush_work to
> out_release_dma and dropped it. Restore it so the work drains before the
> IRQ and DMA are released, as floppy_module_exit() already does.
> 
> Fixes: 070ad7e793dc ("floppy: convert to delayed work and single-thread wq")
> Assisted-by: Claude:claude-opus-4-8
> Signed-off-by: Karl Mehltretter <[email protected]>

Reviewed-by: Denis Efremov (Oracle) <[email protected]>

> ---
> 
> Noticed while running mainline on an emulated Acorn RiscPC, a custom
> personal QEMU machine. It has no floppy controller and rpc_defconfig
> sets CONFIG_BLK_DEV_FD=y, so every boot takes the no-controller error
> path. No disk is registered there, so the drained work takes the
> empty-request fast path and just unlocks the FDC, leaving only the
> spurious message.
> 
> Verified with 100 QEMU boots per platform on v7.2-rc4, no controller
> present. "work still pending" appeared on an unfixed kernel vs with this
> patch:
> 
>   Acorn RiscPC, rpc_defconfig: 100/100 -> 0/100
>   x86_64 defconfig, qemu -M q35: 6/100 -> 0/100
> 
> With a controller present on qemu -M pc, reading and writing a 1.44M
> floppy image still works.
> 
>  drivers/block/floppy.c | 2 ++
>  1 file changed, 2 insertions(+)
> 
> diff --git a/drivers/block/floppy.c b/drivers/block/floppy.c
> index f04397b8e381..6cfd114d27df 100644
> --- a/drivers/block/floppy.c
> +++ b/drivers/block/floppy.c
> @@ -4744,6 +4744,8 @@ static int __init do_floppy_init(void)
>  		}
>  	}
>  out_release_dma:
> +	/* Drain the queued redo_fd_request() before releasing IRQ and DMA. */
> +	flush_workqueue(floppy_wq);
>  	if (atomic_read(&usage_count))
>  		floppy_release_irq_and_dma();
>  out_unreg_driver:

Thanks,
Denis