[PATCH v6 00/12] block,md,nvme: correct handling of unsupported P2PDMA transfers

md treats an unsupported P2PDMA transfer to a member as success, and
nvme-rdma retries one forever.  Whether peer memory can be DMA-mapped
depends on the PCIe topology between the two devices, and since v6.17
the failure completes as BLK_STS_INVAL: retryable for multipath and
deliberately ignored by md for member failures, so mirrors silently
diverge.

v1-v3 restored BLK_STS_TARGET for these failures and tagged P2PDMA
bios in md.  Logan Gunthorpe proposed a dedicated BLK_STS_P2PDMA
instead, so no consumer needs to know whether an I/O was P2P, and
wrote the core patches; v4 onward is built on them.  Patches 1 and 5
are his and keep his authorship.

  1  block: add BLK_STS_P2PDMA (stable, v6.17)
  2  md: ensure REQ_NOMERGE is set on P2PDMA bios
  3  md/raid1: serialize non-write-behind writes on CollisionCheck
     rdevs (pre-existing bug patch 4 would widen; stable)
  4  md/raid1: no write-behind for P2PDMA bios
  5  md/raid1,raid10: factor out raid1_write_error() helper
  6  md/raid1,raid10: keep REQ_NOMERGE on narrow_write_error()
     retry clones
  7  md/raid1,raid10: skip futile retries on P2PDMA mapping
     failures
  8  md/raid1,raid10: set IO_BLOCKED in case of BLK_STS_P2PDMA
  9  nvme-rdma: use ib_dma_map_sgtable_attrs() (stable, v7.1;
     dependency of patch 10)
 10  nvme-rdma: return BLK_STS_P2PDMA (stable, v7.1; needs patches
     1 and 9)
 11  nvme-rdma: ratelimit the map-failure error message (cleanup)
 12  nvme-rdma: factor out the scatterlist DMA mapping helper
     (cleanup)

Routing: patch 1 block, 2-8 md, 9-12 nvme; 7, 8 and 10 use the new
status.  Patch 1 alone stops the divergence and the dm-multipath
requeue loop; the nvme-rdma loop also needs 9-10; everything else
refines the fallout, so the series bisects safely.  The md patches
fix a v7.2-rc1 regression (02666132403a), except 3 (older bug,
stable) and 5 (refactor).  11 and 12 are cleanup only and can be
deferred if you would rather not carry them at -rc.

Tested with the QEMU raid1/raid10 error matrix and a ConnectX-4 Lx.
After patch 1, block-layer error injection accepts status=P2PDMA, so
the md completion paths can be exercised on any member with no P2P
hardware.  The patches were developed with AI assistance (see the
Assisted-by trailers); all code was human-reviewed and tested.

Against v7.2-rc4 (Logan's base).

Changes in v6:
 - patches 7, 9, 10: picked up Logan's Reviewed-by; on 7 it replaces
   his now-stale Signed-off-by, as he asked
 - patch 10: the map-failure ratelimit conversion moves out to its
   own patch 11 (Logan); the stable note now names both prerequisites
 - new patch 12: the data and the metadata mapping share a helper
   (Logan's suggestion on patch 9).  Kept out of 9 so the
   stable-tagged fix stays minimal

Changes in v5:
 - patch 7: From: is now Mykola, at Logan's request; patch 8 follows
   for consistency.  Logan keeps Signed-off-by on both,
   Co-developed-by on 8
 - patch 8: raid10 declares bio up front and bi_status sits in a
   blk_status_t local in both files.
 - old patch 9 split: 9 is the mechanical sgtable conversion,
   10 the -EREMOTEIO -> BLK_STS_P2PDMA translation; both stable
   since 10 needs 9

Changes in v4:
 - new BLK_STS_P2PDMA (Logan) replaces restoring BLK_STS_TARGET; the
   R1BIO_P2PDMA/R10BIO_P2PDMA state bits are gone and the md changes
   shrink to completion-time status tests
 - blk_dma_map_iter_start() gets the explicit
   PCI_P2PDMA_MAP_NOT_SUPPORTED case (Logan's patch; v3 kept
   default: only)
 - write completions record the whole failed range as bad blocks
   instead of narrow_write_error()'s per-block retries; v3's coarse
   retry is gone -- the new status is deterministic, nothing to
   re-attempt

Link: https://lore.kernel.org/linux-raid/[email protected]/ [v1]
Link: https://lore.kernel.org/linux-raid/[email protected]/ [v2]
Link: https://lore.kernel.org/linux-raid/[email protected]/ [v3]
Link: https://lore.kernel.org/linux-raid/[email protected]/ [v4]
Link: https://lore.kernel.org/linux-raid/[email protected]/ [v5]
Link: https://lore.kernel.org/linux-raid/[email protected]/ [Logan's proposal]

Logan Gunthorpe (2):
  block: add BLK_STS_P2PDMA for unsupported peer-to-peer transfers
  md/raid1,raid10: factor out raid1_write_error() helper

Mykola Marzhan (10):
  md: ensure REQ_NOMERGE is set on P2PDMA bios
  md/raid1: serialize non-write-behind writes on CollisionCheck rdevs
  md/raid1: don't use write-behind for P2PDMA bios
  md/raid1,raid10: keep REQ_NOMERGE on narrow_write_error() retry clones
  md/raid1,raid10: skip futile retries on P2PDMA mapping failures
  md/raid1,raid10: set IO_BLOCKED in case of BLK_STS_P2PDMA
  nvme-rdma: use ib_dma_map_sgtable_attrs()
  nvme-rdma: return BLK_STS_P2PDMA for unsupported P2P transfers
  nvme-rdma: ratelimit the map-failure error message
  nvme-rdma: factor out the scatterlist DMA mapping helper

 block/blk-core.c          |  3 +++
 block/blk-mq-dma.c        |  3 ++-
 drivers/md/md.c           | 10 ++++++--
 drivers/md/md.h           | 15 +++++++++++
 drivers/md/raid1-10.c     | 16 ++++++++++++
 drivers/md/raid1.c        | 47 ++++++++++++++++++++--------------
 drivers/md/raid10.c       | 27 ++++++++++----------
 drivers/nvme/host/rdma.c  | 54 +++++++++++++++++++++++++++------------
 include/linux/blk_types.h | 10 ++++++++
 9 files changed, 134 insertions(+), 51 deletions(-)


base-commit: 1590cf0329716306e948a8fc29f1d3ee87d3989f
-- 
2.52.0