[PATCH] Bluetooth: btrsi: Move set_bt_context after successful HCI registration

In rsi_hci_attach(), ops->set_bt_context() stores the newly allocated
h_adapter into common->bt_adapter before hci_alloc_dev() and
hci_register_dev() are called. If either of these fails, h_adapter
is freed but common->bt_adapter remains a non-NULL dangling pointer.

This causes a deterministically reachable use-after-free when the
device operates in a BT+WiFi coexistence mode and CONFIG_RSI_COEX
is enabled. The following software-only trigger paths exist:

  1. SDIO driver .remove  (rsi_disconnect)
  2. USB  driver .disconnect (rsi_disconnect)
  3. SDIO driver .shutdown (rsi_shutdown)
  4. Hibernation .freeze  (rsi_freeze)

All four paths check:
    if (IS_ENABLED(CONFIG_RSI_COEX) && coex_mode > 1 && bt_adapter)
        rsi_bt_ops.detach(bt_adapter);  // use-after-free

coex_mode is set during rsi_91x_init(), before rsi_hci_attach() is
called, and is not cleared on attach failure. Since set_bt_context()
already wrote bt_adapter before the failure, the deinit paths see a
non-NULL dangling pointer and proceed to detach it.

Fix this by moving set_bt_context() after hci_register_dev() succeeds.
On failure paths bt_adapter stays NULL, and the deinit callers correctly
skip the detach call.

Signed-off-by: Chen Changcheng <[email protected]>
---
 drivers/bluetooth/btrsi.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/drivers/bluetooth/btrsi.c b/drivers/bluetooth/btrsi.c
index 59ad0b9b14c3..3f802b7c83f7 100644
--- a/drivers/bluetooth/btrsi.c
+++ b/drivers/bluetooth/btrsi.c
@@ -107,7 +107,6 @@ static int rsi_hci_attach(void *priv, struct rsi_proto_ops *ops)
 		return -ENOMEM;
 
 	h_adapter->priv = priv;
-	ops->set_bt_context(priv, h_adapter);
 	h_adapter->proto_ops = ops;
 
 	hdev = hci_alloc_dev();
@@ -136,6 +135,8 @@ static int rsi_hci_attach(void *priv, struct rsi_proto_ops *ops)
 		goto err;
 	}
 
+	ops->set_bt_context(priv, h_adapter);
+
 	return 0;
 err:
 	h_adapter->hdev = NULL;
-- 
2.25.1