[PATCH v5 3/3] clk: nuvoton: ma35d1: fix ma35d1_clk_pll_determine_rate logic

ma35d1_clk_pll_determine_rate() called ma35d1_pll_find_closest()
unconditionally before the switch statement, and then every case
branch overwrote pll_freq by reading the current hardware registers.
For CAPLL and DDRPLL this means find_closest() ran unnecessarily
(and incorrectly, since those PLLs are read-only) and its result
was silently discarded.

Fix by moving the find_closest() call inside the APLL/EPLL/VPLL
branch where it belongs.  Split CAPLL and DDRPLL into separate case
labels mirroring ma35d1_clk_pll_recalc_rate(), with a shared
req->rate = pll_freq tail after the switch and an explicit default
label for unknown PLL IDs.

Fixes: 691521a367cf ("clk: nuvoton: Add clock driver for ma35d1 clock controller")
Signed-off-by: Joey Lu <[email protected]>
Reviewed-by: Alexandre Mergnat <[email protected]>
---
 drivers/clk/nuvoton/clk-ma35d1-pll.c | 31 ++++++++++++++--------------
 1 file changed, 16 insertions(+), 15 deletions(-)

diff --git a/drivers/clk/nuvoton/clk-ma35d1-pll.c b/drivers/clk/nuvoton/clk-ma35d1-pll.c
index eb9d69d2077b..878b23bb5918 100644
--- a/drivers/clk/nuvoton/clk-ma35d1-pll.c
+++ b/drivers/clk/nuvoton/clk-ma35d1-pll.c
@@ -255,32 +255,33 @@ static int ma35d1_clk_pll_determine_rate(struct clk_hw *hw,
 	if (req->best_parent_rate < PLL_FREF_MIN_FREQ || req->best_parent_rate > PLL_FREF_MAX_FREQ)
 		return -EINVAL;
 
-	ret = ma35d1_pll_find_closest(pll, req->rate, req->best_parent_rate,
-				      reg_ctl, &pll_freq);
-	if (ret < 0)
-		return ret;
-
 	switch (pll->id) {
 	case CAPLL:
+		/* SMIC design: single control register */
 		reg_ctl[0] = readl_relaxed(pll->ctl0_base);
 		pll_freq = ma35d1_calc_smic_pll_freq(reg_ctl[0], req->best_parent_rate);
-		req->rate = pll_freq;
-
-		return 0;
+		break;
 	case DDRPLL:
-	case APLL:
-	case EPLL:
-	case VPLL:
+		/* Standard design: read current rate, not configurable */
 		reg_ctl[0] = readl_relaxed(pll->ctl0_base);
 		reg_ctl[1] = readl_relaxed(pll->ctl1_base);
 		pll_freq = ma35d1_calc_pll_freq(pll->mode, reg_ctl, req->best_parent_rate);
-		req->rate = pll_freq;
-
+		break;
+	case APLL:
+	case EPLL:
+	case VPLL:
+		/* Configurable PLLs: find closest achievable rate */
+		ret = ma35d1_pll_find_closest(pll, req->rate, req->best_parent_rate,
+					      reg_ctl, &pll_freq);
+		if (ret < 0)
+			return ret;
+		break;
+	default:
+		req->rate = 0;
 		return 0;
 	}
 
-	req->rate = 0;
-
+	req->rate = pll_freq;
 	return 0;
 }
 
-- 
2.43.0