RE: [PATCH 04/13] arm64: dts: exynos8855: add cmu_top & cmu_peric clock DT nodes

Hi Krzysztof,

> -----Original Message-----
> From: Krzysztof Kozlowski <[email protected]>
> Sent: Tuesday, July 28, 2026 5:30 PM
> To: raghav.s <[email protected]>; [email protected];
> [email protected]; [email protected];
> [email protected]; [email protected]; [email protected];
> [email protected]; [email protected]; [email protected]
> Cc: [email protected]; [email protected];
> [email protected]; [email protected]; linux-
> [email protected]; [email protected];
> [email protected]; [email protected];
> [email protected]
> Subject: Re: [PATCH 04/13] arm64: dts: exynos8855: add cmu_top &
> cmu_peric clock DT nodes
> 
> On 28/07/2026 14:11, raghav.s wrote:
> > Add required dt node for cmu_top & cmu_peric block
> >
> > Signed-off-by: raghav.s <[email protected]>
> > ---
> >  arch/arm64/boot/dts/exynos/exynos8855.dtsi | 24
> > ++++++++++++++++++++++
> >  1 file changed, 24 insertions(+)
> 
> Please organize your patches in reasonable order. DTS is never in the middle,
> see submitting patches (both documents) and maintainer-soc profile.
> 
The thought was to add clks block wise and hence we see DTS coming in between but for the other blocks. 
e.g. patch-2 and 3 adds binding and driver for TOP and PERIC and this patch-4 adds DTS. 
And patch-5 and 6 adds binding and driver for PERIS and patch-7 adds DTS and so on.

Cover-letter should have explained this. 

Are you suggesting to re-order all the binding first followed by all blocks driver and then add a single DTS for all clock controller? 

Does current approach helps in review? 

> Best regards,
> Krzysztof