[PATCH v9 03/12] dt-bindings: clk: zte: Add zx297520v3 LSP clock and reset controller
Stefan Dösinger <[email protected]> Sun, 02 Aug 2026 23:33:35 +0300
| Newsgroups | org.kernel.vger.linux-clk,dev.linux.lists.mfd,org.infradead.lists.linux-arm-kernel,org.infradead.lists.linux-phy,org.kernel.vger.linux-devicetree,org.kernel.vger.linux-kernel |
|---|---|
| Message-ID | <[email protected]> |
The clock controller of the zx297520v3 Low Speed Peripherals is relatively clean. One register per device with gates, muxes and resets and for some devices a divider. There are even bits in the matrix controller to control propagation of clock lines down to LSP. The clocks are sorted by register address and I am convinced that the device list is complete. There are, however, a few more registers that are likely extra dividers for TDM and I2S devices. Reviewed-by: Krzysztof Kozlowski <[email protected]> Signed-off-by: Stefan Dösinger <[email protected]> --- Patch changelog: v8: *) Start clock indices at 0 *) A minor grammar fix in the second paragraph of the binding prose v5: Rename from lspclk to lspcrm Remove matrixcrm from example v4: Order properties compatible->reg->clocks->clock->names->#cells --- .../bindings/clock/zte,zx297520v3-lspcrm.yaml | 101 +++++++++++++++++++++ MAINTAINERS | 1 + include/dt-bindings/clock/zte,zx297520v3-clk.h | 37 ++++++++ include/dt-bindings/reset/zte,zx297520v3-reset.h | 19 ++++ 4 files changed, 158 insertions(+) diff --git a/Documentation/devicetree/bindings/clock/zte,zx297520v3-lspcrm.yaml b/Documentation/devicetree/bindings/clock/zte,zx297520v3-lspcrm.yaml new file mode 100644 index 000000000000..cfad0e0372f4 --- /dev/null +++ b/Documentation/devicetree/bindings/clock/zte,zx297520v3-lspcrm.yaml @@ -0,0 +1,101 @@ +# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) +%YAML 1.2 +--- +$id: http://devicetree.org/schemas/clock/zte,zx297520v3-lspcrm.yaml# +$schema: http://devicetree.org/meta-schemas/core.yaml# + +title: ZTE zx297520v3 SoC LSP clock and reset controller + +maintainers: + - Stefan Dösinger <[email protected]> + +description: | + This clock and reset controller controls low speed peripherals on the board. + This is a relatively isolated subsystem containing UART, I2C, I2S and SPI + devices. The controller is responsible for bringing the devices out of reset + and enabling their clocks as needed. + + The controller receives its clock signals from the matrix controller, and + these signals need to be declared as clock inputs. + + All available clocks are defined as preprocessor macros in the + "include/dt-bindings/clock/zte,zx297520v3-clk.h" header. Resets are defined in + the "include/dt-bindings/reset/zte,zx297520v3-reset.h" header. + +properties: + compatible: + const: zte,zx297520v3-lspcrm + + reg: + maxItems: 1 + + clocks: + items: + - description: Main PLL divided by 5 output from matrixcrm (124.8 MHz) + - description: Main PLL divided by 4 output from matrixcrm (156 MHz) + - description: Main PLL divided by 6 output from matrixcrm (104 MHz) + - description: Main PLL divided by 8 output from matrixcrm (78 MHz) + - description: Main PLL divided by 12 output from matrixcrm (52 MHz) + - description: Main oscillator output from matrixcrm (26 MHz) + - description: Timer oscillator output from matrixcrm (32 kHz) + - description: LSP pclk output from matrixcrm (26 MHz) + - description: TDM wclk mux output from matrixcrm + - description: DPLL divided by 4 output from matrixcrm (122.88 MHz) + + clock-names: + items: + - const: mpll-d5 + - const: mpll-d4 + - const: mpll-d6 + - const: mpll-d8 + - const: mpll-d12 + - const: osc26m + - const: osc32k + - const: pclk + - const: tdm-wclk + - const: dpll-d4 + + resets: + maxItems: 1 + + "#clock-cells": + const: 1 + + "#reset-cells": + const: 1 + +required: + - compatible + - reg + - clocks + - clock-names + - resets + - "#clock-cells" + - "#reset-cells" + +additionalProperties: false + +examples: + - | + #include <dt-bindings/clock/zte,zx297520v3-clk.h> + #include <dt-bindings/reset/zte,zx297520v3-reset.h> + + clock-controller@1400000 { + compatible = "zte,zx297520v3-lspcrm"; + reg = <0x01400000 0x100>; + clocks = <&matrixcrm ZX297520V3_LSP_MPLL_D5_WCLK>, + <&matrixcrm ZX297520V3_LSP_MPLL_D4_WCLK>, + <&matrixcrm ZX297520V3_LSP_MPLL_D6_WCLK>, + <&matrixcrm ZX297520V3_LSP_MPLL_D8_WCLK>, + <&matrixcrm ZX297520V3_LSP_MPLL_D12_WCLK>, + <&matrixcrm ZX297520V3_LSP_OSC26M_WCLK>, + <&matrixcrm ZX297520V3_LSP_OSC32K_WCLK>, + <&matrixcrm ZX297520V3_LSP_PCLK>, + <&matrixcrm ZX297520V3_LSP_TDM_WCLK>, + <&matrixcrm ZX297520V3_LSP_DPLL_D4_WCLK>; + clock-names = "mpll-d5", "mpll-d4", "mpll-d6", "mpll-d8", "mpll-d12", + "osc26m", "osc32k", "pclk", "tdm-wclk", "dpll-d4"; + resets = <&matrixcrm ZX297520V3_LSP_RESET>; + #clock-cells = <1>; + #reset-cells = <1>; + }; diff --git a/MAINTAINERS b/MAINTAINERS index 9a919e60254a..e01ef014c110 100644 --- a/MAINTAINERS +++ b/MAINTAINERS @@ -3910,6 +3910,7 @@ L: [email protected] (moderated for non-subscribers) S: Odd fixes F: Documentation/arch/arm/zte/ F: Documentation/devicetree/bindings/arm/zte.yaml +F: Documentation/devicetree/bindings/clock/zte,zx297520v3-lspcrm.yaml F: Documentation/devicetree/bindings/clock/zte,zx297520v3-matrixcrm.yaml F: Documentation/devicetree/bindings/clock/zte,zx297520v3-topcrm.yaml F: arch/arm/boot/dts/zte/ diff --git a/include/dt-bindings/clock/zte,zx297520v3-clk.h b/include/dt-bindings/clock/zte,zx297520v3-clk.h index a8477e9b2a14..8824740468a3 100644 --- a/include/dt-bindings/clock/zte,zx297520v3-clk.h +++ b/include/dt-bindings/clock/zte,zx297520v3-clk.h @@ -104,4 +104,41 @@ #define ZX297520V3_SRAM0_PCLK 38 #define ZX297520V3_GSM_CFG_PCLK 39 +#define ZX297520V3_TIMER_L1_WCLK 0 +#define ZX297520V3_TIMER_L1_PCLK 1 +#define ZX297520V3_WDT_L2_WCLK 2 +#define ZX297520V3_WDT_L2_PCLK 3 +#define ZX297520V3_WDT_L3_WCLK 4 +#define ZX297520V3_WDT_L3_PCLK 5 +#define ZX297520V3_PWM_WCLK 6 +#define ZX297520V3_PWM_PCLK 7 +#define ZX297520V3_I2S0_WCLK 8 +#define ZX297520V3_I2S0_PCLK 9 +#define ZX297520V3_I2S1_WCLK 10 +#define ZX297520V3_I2S1_PCLK 11 +#define ZX297520V3_QSPI_WCLK 12 +#define ZX297520V3_QSPI_PCLK 13 +#define ZX297520V3_UART1_WCLK 14 +#define ZX297520V3_UART1_PCLK 15 +#define ZX297520V3_I2C1_WCLK 16 +#define ZX297520V3_I2C1_PCLK 17 +#define ZX297520V3_SPI0_WCLK 18 +#define ZX297520V3_SPI0_PCLK 19 +#define ZX297520V3_TIMER_LB_WCLK 20 +#define ZX297520V3_TIMER_LB_PCLK 21 +#define ZX297520V3_TIMER_LC_WCLK 22 +#define ZX297520V3_TIMER_LC_PCLK 23 +#define ZX297520V3_UART2_WCLK 24 +#define ZX297520V3_UART2_PCLK 25 +#define ZX297520V3_WDT_LE_WCLK 26 +#define ZX297520V3_WDT_LE_PCLK 27 +#define ZX297520V3_TIMER_LF_WCLK 28 +#define ZX297520V3_TIMER_LF_PCLK 29 +#define ZX297520V3_SPI1_WCLK 30 +#define ZX297520V3_SPI1_PCLK 31 +#define ZX297520V3_TIMER_L11_WCLK 32 +#define ZX297520V3_TIMER_L11_PCLK 33 +#define ZX297520V3_TDM_WCLK 34 +#define ZX297520V3_TDM_PCLK 35 + #endif /* __DT_BINDINGS_CLOCK_ZX297520V3_H */ diff --git a/include/dt-bindings/reset/zte,zx297520v3-reset.h b/include/dt-bindings/reset/zte,zx297520v3-reset.h index d79fa601afa6..303fbef12a42 100644 --- a/include/dt-bindings/reset/zte,zx297520v3-reset.h +++ b/include/dt-bindings/reset/zte,zx297520v3-reset.h @@ -39,4 +39,23 @@ #define ZX297520V3_VOU_RESET 9 #define ZX297520V3_LSP_RESET 10 +#define ZX297520V3_TIMER_L1_RESET 0 +#define ZX297520V3_WDT_L2_RESET 1 +#define ZX297520V3_WDT_L3_RESET 2 +#define ZX297520V3_PWM_RESET 3 +#define ZX297520V3_I2S0_RESET 4 +#define ZX297520V3_I2S1_RESET 5 +#define ZX297520V3_QSPI_RESET 6 +#define ZX297520V3_UART1_RESET 7 +#define ZX297520V3_I2C1_RESET 8 +#define ZX297520V3_SPI0_RESET 9 +#define ZX297520V3_TIMER_LB_RESET 10 +#define ZX297520V3_TIMER_LC_RESET 11 +#define ZX297520V3_UART2_RESET 12 +#define ZX297520V3_WDT_LE_RESET 13 +#define ZX297520V3_TIMER_LF_RESET 14 +#define ZX297520V3_SPI1_RESET 15 +#define ZX297520V3_TIMER_L11_RESET 16 +#define ZX297520V3_TDM_RESET 17 + #endif /* __DT_BINDINGS_RESET_ZX297520V3_H */ -- 2.54.0