[PATCH 00/15] Add initial support for Qualcomm Kuno SoC

This series adds initial support for the Qualcomm Kuno SoC and the Kuno
IDP reference board.

Kuno is a 32-bit ARM (Cortex-A7) Qualcomm platform. This series brings up
the essential SoC infrastructure required to boot to a serial console:

  - Global Clock Controller (GCC) and RPMh clock controller
  - RPMh power domains
  - Interconnect (NoC) provider
  - TLMM pin controller
  - PDC interrupt controller and SCM firmware interface
  - Devicetree for the SoC and the Kuno IDP board

The soc: qcom: geni-se patch allows the GENI serial engine driver to be
selected on 32-bit ARM Qualcomm SoCs, which the debug UART console
depends on.

Signed-off-by: Hardeep Sharma <[email protected]>
---
Hardeep Sharma (15):
      soc: qcom: geni-se: allow selection on 32-bit ARM Qualcomm SoCs
      dt-bindings: power: rpmpd: Document Kuno RPMh power domains
      pmdomain: qcom: rpmhpd: Add power domains for Kuno
      dt-bindings: clock: qcom,rpmhcc: Add Kuno RPMh clock controller
      clk: qcom: clk-rpmh: Add support for Kuno RPMh clocks
      dt-bindings: interconnect: Add Qualcomm Kuno NoC
      interconnect: qcom: Add Kuno interconnect provider driver
      dt-bindings: pinctrl: qcom: Add Kuno TLMM
      pinctrl: qcom: Add Kuno pinctrl driver
      dt-bindings: clock: qcom: Add Kuno Global Clock Controller
      clk: qcom: Add Global Clock Controller driver for Kuno
      dt-bindings: interrupt-controller: qcom,pdc: Add Kuno compatible string
      dt-bindings: firmware: qcom,scm: Document SCM on Kuno SoC
      dt-bindings: arm: qcom: Document Kuno IDP board
      ARM: dts: qcom: Add initial device tree for Kuno SoC

 Documentation/devicetree/bindings/arm/qcom.yaml    |    6 +
 .../devicetree/bindings/clock/qcom,kuno-gcc.yaml   |   56 +
 .../devicetree/bindings/clock/qcom,rpmhcc.yaml     |    1 +
 .../devicetree/bindings/firmware/qcom,scm.yaml     |    1 +
 .../bindings/interconnect/qcom,kuno-rpmh.yaml      |   72 +
 .../bindings/interrupt-controller/qcom,pdc.yaml    |    1 +
 .../bindings/pinctrl/qcom,kuno-tlmm.yaml           |  109 ++
 .../devicetree/bindings/power/qcom,rpmpd.yaml      |    1 +
 arch/arm/boot/dts/qcom/Makefile                    |    1 +
 arch/arm/boot/dts/qcom/qcom-kuno-idp.dts           |   25 +
 arch/arm/boot/dts/qcom/qcom-kuno.dtsi              |  423 ++++++
 drivers/clk/qcom/Kconfig                           |   10 +
 drivers/clk/qcom/Makefile                          |    1 +
 drivers/clk/qcom/clk-rpmh.c                        |   15 +
 drivers/clk/qcom/gcc-kuno.c                        | 1438 ++++++++++++++++++++
 drivers/interconnect/qcom/Kconfig                  |   13 +
 drivers/interconnect/qcom/Makefile                 |    2 +
 drivers/interconnect/qcom/kuno.c                   |  978 +++++++++++++
 drivers/pinctrl/qcom/Kconfig.msm                   |   11 +
 drivers/pinctrl/qcom/Makefile                      |    1 +
 drivers/pinctrl/qcom/pinctrl-kuno.c                |  796 +++++++++++
 drivers/pmdomain/qcom/rpmhpd.c                     |   16 +
 drivers/soc/qcom/Kconfig                           |    1 -
 include/dt-bindings/clock/qcom,kuno-gcc.h          |   95 ++
 include/dt-bindings/interconnect/qcom,kuno.h       |   89 ++
 25 files changed, 4161 insertions(+), 1 deletion(-)
---
base-commit: 0d33d21e47d9dc66f91e44da3fc9220c74d93df7
change-id: 20260809-kuno-soc-support-1dab826de0bf

Best regards,
--  
Hardeep Sharma <[email protected]>