Re: [PATCH] clk: qcom: ipq-cmn-pll: keep the CMN block bus clocks enabled

On 8/19/2026 9:00 PM, Konrad Dybcio wrote:
> On 8/4/26 1:03 PM, Jie Luo wrote:
>>
>>
>> On 8/3/2026 5:10 PM, Stanislaw Pal wrote:
>>>> The CMN PLL AHB/SYS clocks will remain enabled as long as a downstream
>>>> consumer of the CMN PLL clocks is active — this behaviour was confirmed
>>>> experimentally on the IPQ9574 platform as example.
>>> That is exactly the mechanism - and it is exactly what IPQ5018 does not
>>> have. On IPQ9574 the nsscc node consumes the CMN PLL outputs in DT:
>>>
>>>   ipq9574.dtsi:
>>>     nsscc: clock-controller@39b00000 {
>>>         clocks = <&xo_board_clk>,
>>>                  <&cmn_pll NSS_1200MHZ_CLK>,
>>>                  <&cmn_pll PPE_353MHZ_CLK>, ...
>>>
>>> so the device link holds the supplier active, which is what your
>>> insmod/devmem experiment shows.
>>>
>>> On IPQ5018 there is no such consumer: nothing in ipq5018.dtsi references
>>> any cmn_pll output clock - the only occurrences of the phandle are the
>>> provider node itself and its own assigned-clocks. The actual users of
>>> the CMN outputs on this SoC (the internal GE PHY and the uniphy blocks)
>>> take them directly in hardware, with no DT linkage, so no device link
>>> ever holds the provider active. A few ms after probe the autosuspend
>>> gates the AHB/SYS clocks, and the box dies on the next bus access -
>>> which is the measured behaviour the patch description quotes.
>>
>> The CMN PLL output clocks do not depend on the AHB or SYS clocks. They
>> continue to operate correctly at the fixed rates even when the AHB
>> and SYS clocks are disabled. Therefore, once the CMN PLL module is
>> loaded, its output clocks are expected to operate at the correct
>> frequencies.
> 
> Linux sees there's no consumers for the clocks the CMN PLL provides
> and gates them, subsequently also gating the PLL itself as all of
> its children become offline.
> 
> I can't find the docs that would show me what IPs consume this block,
> could you please help out here Jie?
> 

On IPQ5018, the CMN PLL provides a 50 MHz output clock that is used as
the reference clock for the connected Ethernet device.

> Konrad