[PATCH v11 4/6] x86/sev: Add support to perform RMP optimizations asynchronously

From: Ashish Kalra <[email protected]>

When SEV-SNP is enabled, all writes to memory are checked to ensure
integrity of SNP guest memory. This imposes performance overhead on the
whole system.

RMPOPT is a new instruction that minimizes the performance overhead of
RMP checks on the hypervisor and on non-SNP guests by allowing RMP
checks to be skipped for 1GB regions of memory that are known not to
contain any SEV-SNP guest memory.

Add support for performing RMP optimizations asynchronously using a
dedicated workqueue.

Enable RMPOPT optimizations for up to 2TB of system RAM starting from
the lowest physical memory address aligned down to a 1GB boundary at
RMP initialization time. RMP checks can initially be skipped for 1GB
memory ranges that do not contain SEV-SNP guest memory (excluding
preassigned pages such as the RMP table and firmware pages). As SNP
guests are launched, RMPUPDATE will disable the corresponding RMPOPT
optimizations.

Suggested-by: Thomas Lendacky <[email protected]>
Suggested-by: Dave Hansen <[email protected]>
Suggested-by: K Prateek Nayak <[email protected]>
Reviewed-by: Ackerley Tng <[email protected]>
Signed-off-by: Ashish Kalra <[email protected]>
---
 arch/x86/virt/svm/sev.c | 160 +++++++++++++++++++++++++++++++++++++++-
 1 file changed, 158 insertions(+), 2 deletions(-)

diff --git a/arch/x86/virt/svm/sev.c b/arch/x86/virt/svm/sev.c
index 8bfd80284836..04b19e64f832 100644
--- a/arch/x86/virt/svm/sev.c
+++ b/arch/x86/virt/svm/sev.c
@@ -19,6 +19,7 @@
 #include <linux/iommu.h>
 #include <linux/amd-iommu.h>
 #include <linux/nospec.h>
+#include <linux/workqueue.h>
 
 #include <asm/sev.h>
 #include <asm/processor.h>
@@ -125,7 +126,18 @@ static void *rmp_bookkeeping __ro_after_init;
 static u64 probed_rmp_base, probed_rmp_size;
 
 static cpumask_var_t rmpopt_cpumask;
-static phys_addr_t rmpopt_pa_start;
+static phys_addr_t rmpopt_pa_start, rmpopt_pa_end;
+
+enum rmpopt_function {
+	RMPOPT_FUNC_VERIFY_AND_REPORT_STATUS,
+	RMPOPT_FUNC_REPORT_STATUS
+};
+
+#define RMPOPT_WORK_TIMEOUT	10000
+
+static struct workqueue_struct *rmpopt_wq;
+static struct delayed_work rmpopt_delayed_work;
+static DEFINE_MUTEX(rmpopt_wq_mutex);
 
 static LIST_HEAD(snp_leaked_pages_list);
 static DEFINE_SPINLOCK(snp_leaked_pages_list_lock);
@@ -565,11 +577,20 @@ static void snp_cleanup_rmpopt(void)
 {
 	int cpu;
 
+	guard(mutex)(&rmpopt_wq_mutex);
+
+	if (!rmpopt_wq)
+		return;
+
+	cancel_delayed_work_sync(&rmpopt_delayed_work);
+	destroy_workqueue(rmpopt_wq);
+
 	for_each_cpu(cpu, rmpopt_cpumask)
 		wrmsrq_on_cpu(cpu, MSR_AMD64_RMPOPT_BASE, 0);
 
 	free_cpumask_var(rmpopt_cpumask);
-	rmpopt_pa_start = 0;
+	rmpopt_pa_start = rmpopt_pa_end = 0;
+	rmpopt_wq = NULL;
 }
 
 void snp_shutdown(void)
@@ -599,6 +620,96 @@ static bool rmpopt_capable(void)
 	       cc_platform_has(CC_ATTR_HOST_SEV_SNP);
 }
 
+/*
+ * RMPOPT: F2 0F 01 FC
+ *   Input:  RAX = system physical address (1GB aligned)
+ *           RCX = operation type
+ *   Output: CF set if the range was optimized
+ */
+static inline bool __rmpopt(u64 pa_start, u64 op_type)
+{
+	bool optimized;
+
+	asm volatile(".byte 0xf2, 0x0f, 0x01, 0xfc"
+		     : "=@ccc" (optimized)
+		     : "a" (pa_start), "c" (op_type)
+		     : "memory", "cc");
+
+	return optimized;
+}
+
+static void rmpopt(u64 pa)
+{
+	u64 pa_start = ALIGN_DOWN(pa, SZ_1G);
+	u64 op_type = RMPOPT_FUNC_VERIFY_AND_REPORT_STATUS;
+
+	__rmpopt(pa_start, op_type);
+}
+
+/*
+ * 'val' is a system physical address.
+ */
+static void rmpopt_smp(void *val)
+{
+	rmpopt((u64)val);
+}
+
+/*
+ * RMPOPT optimizations skip RMP checks at 1GB granularity if this
+ * range of memory does not contain any SNP guest memory.
+ */
+static void rmpopt_work_handler(struct work_struct *work)
+{
+	cpumask_var_t follower_mask;
+	phys_addr_t pa;
+	int this_cpu;
+
+	pr_info("Attempt RMP optimizations on physical address range @1GB alignment [0x%016llx - 0x%016llx]\n",
+		rmpopt_pa_start, rmpopt_pa_end);
+
+	if (!alloc_cpumask_var(&follower_mask, GFP_KERNEL)) {
+		pr_warn("RMP optimization pass skipped: cpumask allocation failed\n");
+		return;
+	}
+
+	/*
+	 * RMPOPT scans the RMP table, stores the result of the scan in the
+	 * reserved processor memory. The RMP scan is the most expensive
+	 * part. If a second RMPOPT occurs, it can skip the expensive scan
+	 * if they can see a cached result in the reserved processor memory.
+	 *
+	 * Do RMPOPT on one CPU alone. Then, follow that up with RMPOPT
+	 * on every other primary thread. Followers are "designed to"
+	 * skip the scan if they see the "cached" scan results.
+	 *
+	 * Pin the worker to the current CPU for the leader loop so that
+	 * this_cpu remains valid and the RMPOPT instruction executes on
+	 * the correct CPU.  Use migrate_disable() rather than get_cpu() to
+	 * prevent migration while still allowing preemption.
+	 */
+	migrate_disable();
+	this_cpu = smp_processor_id();
+
+	cpumask_andnot(follower_mask, rmpopt_cpumask,
+		       topology_sibling_cpumask(this_cpu));
+
+	for (pa = rmpopt_pa_start; pa < rmpopt_pa_end; pa += SZ_1G)
+		rmpopt(pa);
+
+	migrate_enable();
+
+	/*
+	 * Followers: run RMPOPT on the remaining cores.  cpus_read_lock() is
+	 * intentionally not held here: CPU hotplug is disabled for the entire
+	 * time SNP is active (see snp_prepare()), and this work only runs while
+	 * SNP is active, so the follower set stays valid across the whole scan.
+	 */
+	for (pa = rmpopt_pa_start; pa < rmpopt_pa_end; pa += SZ_1G)
+		on_each_cpu_mask(follower_mask, rmpopt_smp, (void *)pa, true);
+
+	free_cpumask_var(follower_mask);
+}
+
 void snp_setup_rmpopt(void)
 {
 	u64 rmpopt_base;
@@ -607,8 +718,38 @@ void snp_setup_rmpopt(void)
 	if (!rmpopt_capable())
 		return;
 
+	guard(mutex)(&rmpopt_wq_mutex);
+
+	/*
+	 * On re-initialization after a legacy SNP shutdown (SNP_SHUTDOWN_EX
+	 * with x86_snp_shutdown=0), snp_shutdown() and thus snp_cleanup_rmpopt()
+	 * are skipped, so the workqueue, delayed work, cpumask and per-CPU
+	 * RMPOPT_BASE MSRs are still set up and valid (SnpEn stayed set and
+	 * CPU hotplug stayed disabled).  Rather than re-doing the setup, which
+	 * would leak the existing state, just re-queue the optimization pass
+	 * to re-optimize any memory the previous SNP session de-optimized.
+	 */
+	if (rmpopt_wq) {
+		queue_delayed_work(rmpopt_wq, &rmpopt_delayed_work, 0);
+		return;
+	}
+
+	/*
+	 * Create an RMPOPT-specific workqueue to avoid scheduling
+	 * RMPOPT workitem on the global system workqueue.
+	 */
+	rmpopt_wq = alloc_workqueue("rmpopt_wq", WQ_UNBOUND, 1);
+	if (!rmpopt_wq) {
+		pr_err("Failed to allocate RMPOPT workqueue\n");
+		return;
+	}
+
+	INIT_DELAYED_WORK(&rmpopt_delayed_work, rmpopt_work_handler);
+
 	if (!zalloc_cpumask_var(&rmpopt_cpumask, GFP_KERNEL)) {
 		pr_err("Failed to allocate RMPOPT cpumask\n");
+		destroy_workqueue(rmpopt_wq);
+		rmpopt_wq = NULL;
 		return;
 	}
 
@@ -630,6 +771,21 @@ void snp_setup_rmpopt(void)
 	 */
 	for_each_cpu(cpu, rmpopt_cpumask)
 		wrmsrq_on_cpu(cpu, MSR_AMD64_RMPOPT_BASE, rmpopt_base);
+
+	rmpopt_pa_end = ALIGN(PFN_PHYS(max_pfn), SZ_1G);
+
+	/* Limit memory scanning to 2TB of RAM */
+	if ((rmpopt_pa_end - rmpopt_pa_start) > SZ_2T) {
+		pr_info("RMPOPT coverage limited to 2TB; memory above 0x%llx not optimized\n",
+			rmpopt_pa_start + SZ_2T);
+		rmpopt_pa_end = rmpopt_pa_start + SZ_2T;
+	}
+
+	/*
+	 * Once all per-CPU RMPOPT tables have been configured, enable RMPOPT
+	 * optimizations on all physical memory.
+	 */
+	queue_delayed_work(rmpopt_wq, &rmpopt_delayed_work, 0);
 }
 EXPORT_SYMBOL_FOR_MODULES(snp_setup_rmpopt, "ccp");
 
-- 
2.43.0