Re: [PATCH v3] cxl/pci: Skip reset detection for DVSEC emulated decoders

Looks like this patch is omitted.

Best Regards,
Guixin Liu


在 2026/8/12 16:23, Guixin Liu 写道:
> After an FLR or an SBR, cxl_reset_done() walks the endpoint's decoders and
> asks __cxl_endpoint_decoder_reset_detected() whether any of them lost its
> committed state. That helper filters on CXL_DECODER_F_ENABLE and then
> samples the Committed bit in the HDM decoder control register at
> cxlhdm->regs.hdm_decoder.
>
> The HDM decoder registers are not always where an enabled decoder's state
> lives. A memory device may describe its ranges through the CXL DVSEC range
> registers instead, and should_emulate_decoders() picks that path in two
> situations: when the component registers expose no HDM decoder capability
> at all, and when the capability exists but firmware left Mem_Enable set
> with the global HDM decoder enable bit clear.
> cxl_setup_hdm_decoder_from_dvsec() publishes the emulated decoders with
> CXL_DECODER_F_ENABLE and CXL_DECODER_F_LOCK set, so they pass the filter,
> and it leaves cxld->commit NULL because there is no register to commit to.
>
> In the first situation regs.hdm_decoder is NULL and the readl() oopses in
> the PCI reset completion path. In the second the pointer is valid but the
> registers are unused, so the Committed bit reads zero and the helper
> reports a reset that did not happen: cxl_reset_done() prints two dev_crit
> lines about an SBR wiping active decoders, taints the kernel, and strips
> CXL_DECODER_F_ENABLE and CXL_DECODER_F_LOCK from every endpoint decoder.
> Losing the lock flag is the more consequential half of that, because it is
> what keeps the emulated ranges from being treated as reprogrammable while
> the driver still cannot change the range registers at run time.
>
> Skip the check when cxld->commit is NULL. Only
> cxl_setup_hdm_decoder_from_dvsec() leaves that callback unset, and
> init_hdm_decoder() installs cxl_decoder_commit() on every decoder that
> does come from the registers, so one test covers both emulation paths and
> no separate test for the NULL register pointer is needed. A range
> described by the DVSEC registers has no Committed bit for a reset to
> clear, so there is nothing here for the post-reset warning to observe.
>
> Fixes: 934edcd436dc ("cxl: Add post-reset warning if reset results in loss of previously committed HDM decoders")
> Signed-off-by: Guixin Liu <[email protected]>
> ---
> This was patch 4/8 of the "cxl: Assorted fixes" series [1]. Per review
> feedback that series is not being reworked as a whole; the fixes are resent
> individually instead.
>
> v2 tested cxlhdm->regs.hdm_decoder for NULL. That test turns out to be
> subsumed by the commit callback test rather than complementary to it: on
> the endpoint path info is never NULL, since
> devm_cxl_endpoint_decoders_setup() passes the address of an on-stack struct
> to both devm_cxl_setup_hdm() and devm_cxl_enumerate_decoders(). A NULL
> regs.hdm_decoder can therefore only come from the "no component registers"
> early return in devm_cxl_setup_hdm(), which requires info->mem_enabled,
> and should_emulate_decoders() then emulates every decoder on the port.
> Keeping both tests would leave one that cannot be reached today, so only
> the commit test is here - say the word if you would rather have the NULL
> test back as a guard on that invariant.
>
> The Sashiko review bot raised two further pre-existing concerns on v2 that
> this patch does not address, since both are about the reset handler's
> synchronisation rather than about which registers it reads:
>
> - cxl_reset_done() holds only the memdev device lock, so nothing excludes
>    an unbind of the cxl_port driver from the endpoint port, which frees the
>    devm allocated cxl_hdm while dev_get_drvdata(&port->dev) keeps returning
>    it. An unbind that has completed is harmless: devres frees the decoders
>    before the cxl_hdm allocation that predates them, so the child walk finds
>    nothing to look at. What is left is the interleaving where the walk has
>    already taken its reference on a decoder, which keeps that device alive
>    past device_del(), and the unbind reaches the cxl_hdm free first. Narrow,
>    and the fix is not local: it means deciding how the PCI error handlers
>    should exclude the port driver's binding.
>
> - cxld->flags is updated with a plain read-modify-write in
>    cxl_endpoint_decoder_clear_reset_flags(), while cxl_decoder_commit() and
>    cxl_decoder_reset() update the same word under cxl_rwsem.region, which
>    __commit() and the region reset paths hold across those calls. Having the
>    reset handler take that rwsem too looks like the natural fix, but it
>    already holds the memdev device lock at that point, so the lock ordering
>    wants review first.
>
> Both look worth doing on their own; happy to follow up with separate
> patches if that is the preference.
>
> v1->v2:
> - rebase onto cxl/next
> - rewrite the commit message to describe the behaviour rather than narrate
>    the code change (Alison Schofield)
>
> v2->v3:
> - test cxld->commit instead of cxlhdm->regs.hdm_decoder, so that decoders
>    emulated from the DVSEC ranges are also skipped when the HDM decoder
>    registers exist but are globally disabled (Richard Cheng)
> - update the subject and the commit message for the widened scope
>
> [1] https://lore.kernel.org/linux-cxl/[email protected]/
>
>   drivers/cxl/core/pci.c | 7 +++++++
>   1 file changed, 7 insertions(+)
>
> diff --git a/drivers/cxl/core/pci.c b/drivers/cxl/core/pci.c
> index 9d807c1a002c..d8b07f86bab0 100644
> --- a/drivers/cxl/core/pci.c
> +++ b/drivers/cxl/core/pci.c
> @@ -683,6 +683,13 @@ static int __cxl_endpoint_decoder_reset_detected(struct device *dev, void *data)
>   	if ((cxld->flags & CXL_DECODER_F_ENABLE) == 0)
>   		return 0;
>   
> +	/*
> +	 * Decoders emulated from the DVSEC range registers have no commit
> +	 * callback and no HDM decoder registers to consult.
> +	 */
> +	if (!cxld->commit)
> +		return 0;
> +
>   	cxlhdm = dev_get_drvdata(&port->dev);
>   	hdm = cxlhdm->regs.hdm_decoder;
>   	ctrl = readl(hdm + CXL_HDM_DECODER0_CTRL_OFFSET(cxld->id));
>
> base-commit: 7098e9cd98a05c0c5de2fae0c2465f9d966fdd07