Re: [PATCH 0/2] arm64: dts: qcom: Add eDP display overlays for hamoa and purwa IoT EVKs

Dmitry Baryshkov <[email protected]>
Newsgroups org.kernel.vger.linux-devicetree,org.kernel.vger.linux-arm-msm,org.kernel.vger.linux-kernel
Message-ID <eemtq4i5xgilmy2g2ap7d3vnvgy2yucttwbujyhnn7otzavbrs@nzg3zbsbcszk> 
On Thu, Aug 06, 2026 at 10:01:19PM +0530, Anand Tiwari wrote:
> Both Hamoa and Purwa IoT EVKs are available in headed and headless
> variants. The headed variants use an eDP display panel connected via
> the DP3 controller, while the headless variants do not include a
> display.

Is DP3 routed to a connector or is it unused?

> 
> Move the eDP-specific nodes out of the base DTS files into separate
> DTBO overlays for each board. This allows the base DTBs to be used
> as-is for headless variants, while the composite DTBs enable eDP
> support on headed variants.

-- 
With best wishes
Dmitry
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.