[PATCH v3 01/15] soc: qcom: geni-se: allow selection on 32-bit ARM Qualcomm SoCs
Hardeep Sharma <[email protected]>
| Newsgroups | org.kernel.vger.linux-devicetree,org.infradead.lists.linux-arm-kernel,org.kernel.vger.linux-arm-msm,org.kernel.vger.linux-clk,org.kernel.vger.linux-gpio,org.kernel.vger.linux-kernel,org.kernel.vger.linux-pm |
|---|---|
| Message-ID | <[email protected]> |
Kuno, a 32-bit ARM Cortex-A7 Qualcomm SoC, uses the GENI-based QUP wrapper for its debug UART. Drop the explicit ARM64 dependency so the driver can be selected on 32-bit ARM as well; QCOM_GENI_SE already sits under the QCOM_SOC menuconfig, which is gated by ARCH_QCOM || COMPILE_TEST, so no replacement dependency is needed. Acked-by: Mukesh Savaliya <[email protected]> Signed-off-by: Hardeep Sharma <[email protected]> --- drivers/soc/qcom/Kconfig | 1 - 1 file changed, 1 deletion(-) diff --git a/drivers/soc/qcom/Kconfig b/drivers/soc/qcom/Kconfig index fd4d4ecd2df0..5b3c9d31fd7f 100644 --- a/drivers/soc/qcom/Kconfig +++ b/drivers/soc/qcom/Kconfig @@ -39,7 +39,6 @@ config QCOM_COMMAND_DB config QCOM_GENI_SE tristate "Qualcomm GENI Serial Engine Driver" - depends on ARM64 || COMPILE_TEST default ARCH_QCOM help This driver is used to manage Generic Interface (GENI) firmware based -- 2.43.0