Re: [PATCH] EDAC/altera: use SDMMC co mpatibles to select A10/S10 IRQ layout

On June 15, 2026 7:15:08 PM UTC, AZ9tumas <[email protected]> wrote:
>The SDMMC ECC IRQ layout selection uses CONFIG_64BIT to distinguish
>between Arria10 and Stratix10 paths. This is architecture-based,
>while the interrupt layout is a hardware property described by DT
>compatible strings.
>
>Select the SDMMC IRQ layout via of_device_is_compatible() checks
>for altr,socfpga-s10-sdmmc-ecc in both altr_portb_setup() and
>altr_edac_a10_device_add().
>
>This keeps the existing behavior for both SoCs while making the
>selection mechanism hardware-descriptive.
>
>Signed-off-by: AZ9tumas <[email protected]>

Please use your legal name to sign off on patches.

Thx.

-- 
Small device. Typos and formatting crap