Re: [PATCH v5 2/2] EDAC/altera: remove remaining CONFIG_64BIT ifdefs in the DB-error path

On 7/8/26 04:11, Rounak Das wrote:
> Convert the last two CONFIG_64BIT ifdefs to the is_s10 flag, so the
> whole driver selects behaviour from the ECC manager compatible.
> 
> s10_edac_dberr_handler() is now built on 32-bit too; the symbols it
> uses are all available there. It only runs when is_s10 is true, so
> Arria10 behaviour is unchanged.
> 
> Signed-off-by: Rounak Das <[email protected]>
> ---
>   drivers/edac/altera_edac.c | 20 ++++++++------------
>   1 file changed, 8 insertions(+), 12 deletions(-)
> 
> diff --git a/drivers/edac/altera_edac.c b/drivers/edac/altera_edac.c
> index 24bdf7f5bac63..1d1e2b5ca14c8 100644
> --- a/drivers/edac/altera_edac.c
> +++ b/drivers/edac/altera_edac.c
> @@ -2058,7 +2058,6 @@ static const struct irq_domain_ops a10_eccmgr_ic_ops = {
>   /************** Stratix 10 EDAC Double Bit Error Handler ************/
>   #define to_a10edac(p, m) container_of(p, struct altr_arria10_edac, m)
>   

Acked-by: Dinh Nguyen <[email protected]>