Re: [PATCH] EDAC/fsl_ddr: use non devm for request_irq()

On Thu, Jul 30, 2026 at 05:16:11PM -0700, Rosen Penev wrote:
> On Thu, Jul 30, 2026 at 11:49 AM Frank Li <[email protected]> wrote:
> >
> > On Tue, Jul 28, 2026 at 06:23:20PM -0700, Rosen Penev wrote:
> > > We need to tear down the irq before edac_mc_free() to avoid a use after
> > > free on teardown as request_irq uses mci as dev_id.
> > >
> > > Signed-off-by: Rosen Penev <[email protected]>
> > > ---
> > >  drivers/edac/fsl_ddr_edac.c | 3 ++-
> > >  1 file changed, 2 insertions(+), 1 deletion(-)
> > >
> > > diff --git a/drivers/edac/fsl_ddr_edac.c b/drivers/edac/fsl_ddr_edac.c
> > > index f4cc89b26954..f1ddd1f47f2a 100644
> > > --- a/drivers/edac/fsl_ddr_edac.c
> > > +++ b/drivers/edac/fsl_ddr_edac.c
> > > @@ -601,7 +601,7 @@ int fsl_mc_err_probe(struct platform_device *op)
> > >
> > >               /* register interrupts */
> > >               pdata->irq = platform_get_irq(op, 0);
> > > -             res = devm_request_irq(&op->dev, pdata->irq,
> > > +             res = request_irq(pdata->irq,
> > >                                      fsl_mc_isr,
> > >                                      IRQF_SHARED,
> > >                                      "[EDAC] MC err", mci);
> > > @@ -639,6 +639,7 @@ void fsl_mc_err_remove(struct platform_device *op)
> > >
> > >       if (edac_op_state == EDAC_OPSTATE_INT) {
> > >               ddr_out32(pdata, FSL_MC_ERR_INT_EN, 0);
> > > +             free_irq(pdata->irq, mci);
> >
> > here already disable hardware irq. Just call
> > synchronize_irq() to make sure pending irq handled.
> AI disagrees with this suggestion:
>
> The reviewer's suggestion to just call synchronize_irq() instead of
> free_irq() is problematic for two reasons:
> 1. Shared IRQ: The handler is registered with IRQF_SHARED. Disabling
> the DDR controller's local IRQ output (ddr_out32(..., 0)) prevents
> this device from asserting the IRQ line, but other devices sharing the
> same IRQ line can still trigger it. Without free_irq, the handler
> remains in the shared action list and can be called with a dangling
> mci pointer after edac_mc_free() — the very UAF this patch aims to
> fix.
> 2. free_irq already synchronizes: free_irq() internally calls
> synchronize_irq() after removing the action from the descriptor. An
> explicit synchronize_irq() before free_irq() would be redundant.

You post too quick, I have not seen this mail yet.

devm_free_irq() here. and add comment why need explicit call it.

Frank

> >
> > Frank
> >
> > >       }
> > >
> > >       ddr_out32(pdata, FSL_MC_ERR_DISABLE,
> > > --
> > > 2.55.0
> > >
> > >