Re: [PATCH v3 5/7] efi/runtime-wrappers: bound the wait for EFI runtime service calls
Yeoreum Yun <[email protected]> Thu, 9 Jul 2026 07:56:18 +0100
| Newsgroups | org.kernel.vger.linux-efi,org.kernel.vger.linux-kernel |
|---|---|
| Message-ID | <[email protected]> |
Hi Berno, > When an EFI runtime service hangs in firmware, the efi_rts_wq worker is > stuck inside the call and cannot be cancelled. __efi_queue_work() then > waits on the completion forever while holding efi_runtime_lock, so every > later EFI caller is wedged until reboot; the only symptom is a "workqueue > lockup" and tasks piling up on the semaphore. > > Replace wait_for_completion() with wait_for_completion_timeout() bounded > by EFI_RTS_TIMEOUT (120 seconds). On timeout, clear EFI_RUNTIME_SERVICES > and return EFI_ABORTED so later callers fail fast at the entry check > instead of each paying another 120 seconds. The wedged worker is > intentionally leaked and keeps ownership of efi_rts_work. > > A worker that only starts running after the timeout would otherwise > dereference efi_rts_work.args, now pointing into the caller's freed stack > frame, and hand stale pointers to firmware. Park it with > efi_rts_park_worker() at the entry of efi_call_rts() when runtime > services are already disabled, before it touches args or enters firmware. > > Known limitation: a worker already inside firmware when the timeout fires > still holds efi_rts_args pointing into the caller's stack frame; if > firmware unblocks afterwards and writes the output buffers, they land in > reused memory. Firmware hung this long rarely recovers; a follow-up could > bounce the buffers through kmalloc. > > Signed-off-by: Breno Leitao <[email protected]> > --- > drivers/firmware/efi/runtime-wrappers.c | 19 ++++++++++++++++++- > 1 file changed, 18 insertions(+), 1 deletion(-) > > diff --git a/drivers/firmware/efi/runtime-wrappers.c b/drivers/firmware/efi/runtime-wrappers.c > index ae974edc0b04e..2ec5cbdf46d07 100644 > --- a/drivers/firmware/efi/runtime-wrappers.c > +++ b/drivers/firmware/efi/runtime-wrappers.c > @@ -118,6 +118,14 @@ union efi_rts_args { > > struct efi_runtime_work efi_rts_work; > > +/* > + * Upper bound on how long we wait for a single EFI runtime service > + * call to finish before declaring firmware wedged. Chosen to be longer > + * than any plausible legitimate call (including UpdateCapsule on slow > + * SPI-NOR) while still bounding userspace wait time. > + */ > +#define EFI_RTS_TIMEOUT (120 * HZ) > + > /* > * efi_queue_work: Queue EFI runtime service call and wait for completion > * @_rts: EFI runtime service function identifier > @@ -234,6 +242,9 @@ static void __nocfi efi_call_rts(struct work_struct *work) > efi_status_t status = EFI_NOT_FOUND; > unsigned long flags; > > + if (!efi_enabled(EFI_RUNTIME_SERVICES)) > + efi_rts_park_worker(); > + > efi_runtime_lock_owner = current; > > arch_efi_call_virt_setup(); > @@ -355,7 +366,13 @@ static efi_status_t __efi_queue_work(enum efi_rts_ids id, > goto exit; > } > > - wait_for_completion(&efi_rts_work.efi_rts_comp); > + if (!wait_for_completion_timeout(&efi_rts_work.efi_rts_comp, > + EFI_RTS_TIMEOUT)) { > + pr_err("EFI runtime service %d wedged in firmware; disabling EFI runtime services\n", > + id); > + clear_bit(EFI_RUNTIME_SERVICES, &efi.flags); > + return EFI_ABORTED; > + } One of my concern is for the UpdateCapsule runtime service. It might have a case where takes more then 2 mins and there's one RFC to support a runtime capsule update for arm platform [1]. But I'm not sure how we can discern whether it's a time consuming or for the bug on the firmware. At least, should EFI_RTS be configurable via Kconfig and boot param (timeout or keep the former behavior -- wait_for_completion without timeout)? Thanks. Link: [1] https://github.com/tianocore/tianocore-wiki.github.io/pull/34 -- Sincerely, Yeoreum Yun