Re: [PATCH v3] staging: sm750fb: fix mono image source stride mismatch in lynxfb_ops_imageblit()

Dan Carpenter <[email protected]> Tue, 28 Jul 2026 18:45:51 +0300
Newsgroups org.kernel.vger.linux-fbdev,dev.linux.lists.linux-staging,org.kernel.vger.linux-kernel,org.kernel.vger.stable
Message-ID <[email protected]>
On Tue, Jul 28, 2026 at 06:10:50PM +0500, Muhammad Bilal wrote:
> sm750_hw_imageblit() advances its monochrome source pointer by
> src_delta per scanline, and computes the correct rounded-up stride
> internally as:
> 
>         bytes_per_scan = (width + start_bit + 7) / 8;
> 
> Its only caller, lynxfb_ops_imageblit(), instead passed src_delta as
> image->width >> 3. For widths not a multiple of 8 this under-counted
> the stride, so the source pointer fell further behind the real
> per-scanline layout on every line, corrupting the rendered image.
> 
> Rather than just fixing the caller's calculation, remove src_delta
> as a parameter entirely and have sm750_hw_imageblit() advance by the
> bytes_per_scan it already computes for itself. There has only ever
> been one caller, and that caller was passing an out-of-sync
> derivative of the same width/start_bit values sm750_hw_imageblit()
> already has, so keeping stride as a separate parameter served no
> purpose beyond letting the two calculations drift apart, which is
> exactly what happened here.
> 
> Rounding up, rather than down, is the direction consistent with the
> rest of the fbdev core: struct fb_image mono bitmap data (the same
> image->data this driver receives) is walked elsewhere with byte
> strides derived from a ceiling division of width by 8. The generic
> mono bit iterator in drivers/video/fbdev/core/fb_imageblit.h advances
> scanlines with "iter->data += BITS_TO_BYTES(iter->width)", and
> BITS_TO_BYTES() (include/linux/bitops.h) is a ceiling division.
> sm750_hw_imageblit()'s own "(width + start_bit + 7) / 8" is that same
> ceiling division with an added start_bit offset, so the caller's
> ">> 3" (floor) was the one calculation out of step with how this data
> layout is handled everywhere else.
> 
> Found by code review of sm750_hw_imageblit()'s internal stride
> calculation against what its only caller was passing in, and
> confirmed with a clean -Werror build. I do not have this hardware,
> so this has not been exercised at runtime on real sm750 silicon.
> 
> Fixes: 81dee67e215b2 ("staging: sm750fb: add sm750 to staging")
> Cc: [email protected]
> Signed-off-by: Muhammad Bilal <[email protected]>
> ---
> v3: Added the version notes below, which Dan pointed out were
>     missing from v2. Added Cc: [email protected], flagged by
>     Greg's patch-bot since the Fixes: tag targets an old (2015)
>     commit. Added the rounding-direction justification Dan asked
>     about, citing fb_imageblit.h's BITS_TO_BYTES() as the existing
>     kernel-wide convention for this same struct fb_image layout.
>     Moved the "no hardware" disclosure from an email reply into the
>     commit message itself, per Dan's request.

Generally the no hardware disclosure would come here under the
--- cut off line.  But I'm not going to nit pick about that, it's
fine.

I see also that the "Pitch value (in bytes)" comment supports rounding
up so this looks good to me.

Reviewed-by: Dan Carpenter <[email protected]>

regards,
dan carpenter