Re: [PATCH v8 9/9] gpio: realtek: Add driver for Realtek DHC RTD1625 SoC

On Sun Jul 26, 2026 at 2:52 PM CEST, Yu-Chun Lin wrote:
> From: Tzuyi Chang <[email protected]>
>
> Add support for the GPIO controller found on Realtek DHC RTD1625 SoCs.
>
> Unlike the existing Realtek GPIO driver (drivers/gpio/gpio-rtd.c),
> which manages pins via shared bank registers, the RTD1625 introduces
> a per-pin register architecture. Each GPIO line now has its own
> dedicated 32-bit control register to manage configuration independently,
> including direction, output value, input value, interrupt enable, and
> debounce. Therefore, this distinct hardware design requires a separate
> driver.
>
> The RTD1625 GPIO controller has a hardware quirk where both 'assert'
> and 'de-assert' interrupts are fired simultaneously on any edge toggle.
> The driver works around this quirk to correctly handle edge interrupts.
>
> Interrupt support is optional for this device, matching the dt-bindings.
> If the interrupts property is not provided, the driver simply skips IRQ
> initialization and operates purely as a basic GPIO controller.
>
> Reviewed-by: Linus Walleij <[email protected]>
> Signed-off-by: Tzuyi Chang <[email protected]>
> Co-developed-by: Yu-Chun Lin <[email protected]>
> Signed-off-by: Yu-Chun Lin <[email protected]>
> ---
> Changes in v8:
> - Add error handlers in td1625_gpio_irq_handle().
> - Move the direction-checking logic from the core to our custom
> reg_mask_xlate() callback.
> - Add Reviewed-by tag from Linus.
> ---

Thanks for the fixes.

Reviewed-by: Mathieu Dubois-Briand <[email protected]>

-- 
Mathieu Dubois-Briand, Bootlin
Embedded Linux and Kernel engineering
https://bootlin.com