[PATCH v2 1/2] gpio: realtek-otto: use __raw_readl/writel in realtek_gpio_update_line_imr()

In preparation for upcoming changes to how bank reads and writes
are defined in this driver, change the ioread32 and iowrite32 to
their __raw variants. The realtek_gpio_update_line_imr() function
is used by all devices regardless of GPIO_PORTS_REVERSED flag and
thus this is the only place where there shouldn't be any byte
swapping whether SWAP_IO_SPACE config is enabled or not and that
is only possible with __raw_readl and __raw_writel.

Reviewed-by: Linus Walleij <[email protected]>
Signed-off-by: Rustam Adilov <[email protected]>
---
 drivers/gpio/gpio-realtek-otto.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/gpio/gpio-realtek-otto.c b/drivers/gpio/gpio-realtek-otto.c
index 4a606bad5848..491fde846d46 100644
--- a/drivers/gpio/gpio-realtek-otto.c
+++ b/drivers/gpio/gpio-realtek-otto.c
@@ -176,10 +176,10 @@ static void realtek_gpio_update_line_imr(struct realtek_gpio_ctrl *ctrl, unsigne
 	u32 reg_val;
 
 	reg += 4 * (line_shift / 32);
-	reg_val = ioread32(reg);
+	reg_val = __raw_readl(reg);
 	reg_val &= ~(REALTEK_GPIO_IMR_LINE_MASK << shift);
 	reg_val |= (irq_type & irq_mask & REALTEK_GPIO_IMR_LINE_MASK) << shift;
-	iowrite32(reg_val, reg);
+	__raw_writel(reg_val, reg);
 }
 
 static void realtek_gpio_irq_ack(struct irq_data *data)
-- 
2.55.0