Re: [PATCH v4] hwmon: Add fan monitoring support for HONOR FMI-XX
| Newsgroups | org.kernel.vger.linux-hwmon |
|---|---|
| Message-ID | <[email protected]> |
> The HONOR FMI-XX firmware exposes a serialized \\GFNS ACPI method. > It returns a status byte and a 16-bit fan speed in RPM for either of two > firmware channels. > > Add a DMI-restricted, read-only hwmon driver using that firmware > interface. The driver deliberately exposes no fan control or direct > Embedded Controller access. > > The interface was validated on firmware 1.09 with fan channel 0 > reporting approximately 2500-2800 RPM. Channel 1 is readable and > remained at 0 RPM during idle and a short CPU load. > > Signed-off-by: Nikita Dubrovskih <[email protected]> Sashiko has reviewed this patch and found no issues. It looks great! -- Sashiko AI review · https://sashiko.dev/#/patchset/[email protected]?part=1