[PATCH v7 1/3] hwmon: (pmbus/tps25990): Rework driver for multi-device support

Rework existing implementation to allow adding support for new
devices to the existing driver. chip_id is used to identify the
current device and differentiate logic where needed.

Changes include:
 - Add an enum listing supported chips
 - Add a structure to hold per-device m, b, R coefficients

Signed-off-by: Stoyan Bogdanov <[email protected]>
---
 drivers/hwmon/pmbus/tps25990.c | 123 +++++++++++++++++++--------------
 1 file changed, 70 insertions(+), 53 deletions(-)

diff --git a/drivers/hwmon/pmbus/tps25990.c b/drivers/hwmon/pmbus/tps25990.c
index 9d318e6509ab..7634ac743025 100644
--- a/drivers/hwmon/pmbus/tps25990.c
+++ b/drivers/hwmon/pmbus/tps25990.c
@@ -47,6 +47,15 @@
 					 PK_MIN_AVG_RST_AVG  | \
 					 PK_MIN_AVG_RST_MIN)
 
+enum chips {
+	tps25990,
+};
+
+struct tps25990_data {
+	struct pmbus_driver_info info;
+	enum chips chip_id;
+};
+
 /*
  * Arbitrary default Rimon value: 1kOhm
  * This correspond to an overcurrent limit of 55A, close to the specified limit
@@ -337,63 +346,65 @@ static const struct regulator_desc tps25990_reg_desc[] = {
 };
 #endif
 
-static const struct pmbus_driver_info tps25990_base_info = {
-	.pages = 1,
-	.format[PSC_VOLTAGE_IN] = direct,
-	.m[PSC_VOLTAGE_IN] = 5251,
-	.b[PSC_VOLTAGE_IN] = 0,
-	.R[PSC_VOLTAGE_IN] = -2,
-	.format[PSC_VOLTAGE_OUT] = direct,
-	.m[PSC_VOLTAGE_OUT] = 5251,
-	.b[PSC_VOLTAGE_OUT] = 0,
-	.R[PSC_VOLTAGE_OUT] = -2,
-	.format[PSC_TEMPERATURE] = direct,
-	.m[PSC_TEMPERATURE] = 140,
-	.b[PSC_TEMPERATURE] = 32100,
-	.R[PSC_TEMPERATURE] = -2,
-	/*
-	 * Current and Power measurement depends on the ohm value
-	 * of Rimon. m is multiplied by 1000 below to have an integer
-	 * and -3 is added to R to compensate.
-	 */
-	.format[PSC_CURRENT_IN] = direct,
-	.m[PSC_CURRENT_IN] = 9538,
-	.b[PSC_CURRENT_IN] = 0,
-	.R[PSC_CURRENT_IN] = -6,
-	.format[PSC_POWER] = direct,
-	.m[PSC_POWER] = 4901,
-	.b[PSC_POWER] = 0,
-	.R[PSC_POWER] = -7,
-	.func[0] = (PMBUS_HAVE_VIN |
-		    PMBUS_HAVE_VOUT |
-		    PMBUS_HAVE_VMON |
-		    PMBUS_HAVE_IIN |
-		    PMBUS_HAVE_PIN |
-		    PMBUS_HAVE_TEMP |
-		    PMBUS_HAVE_STATUS_VOUT |
-		    PMBUS_HAVE_STATUS_IOUT |
-		    PMBUS_HAVE_STATUS_INPUT |
-		    PMBUS_HAVE_STATUS_TEMP |
-		    PMBUS_HAVE_SAMPLES),
-	.read_word_data = tps25990_read_word_data,
-	.write_word_data = tps25990_write_word_data,
-	.read_byte_data = tps25990_read_byte_data,
-	.write_byte_data = tps25990_write_byte_data,
+static const struct pmbus_driver_info tps25990_base_info[] = {
+	[tps25990] = {
+		.pages = 1,
+		.format[PSC_VOLTAGE_IN] = direct,
+		.m[PSC_VOLTAGE_IN] = 5251,
+		.b[PSC_VOLTAGE_IN] = 0,
+		.R[PSC_VOLTAGE_IN] = -2,
+		.format[PSC_VOLTAGE_OUT] = direct,
+		.m[PSC_VOLTAGE_OUT] = 5251,
+		.b[PSC_VOLTAGE_OUT] = 0,
+		.R[PSC_VOLTAGE_OUT] = -2,
+		.format[PSC_TEMPERATURE] = direct,
+		.m[PSC_TEMPERATURE] = 140,
+		.b[PSC_TEMPERATURE] = 32100,
+		.R[PSC_TEMPERATURE] = -2,
+		/*
+		 * Current and Power measurement depends on the ohm value
+		 * of Rimon. m is multiplied by 1000 below to have an integer
+		 * and -3 is added to R to compensate.
+		 */
+		.format[PSC_CURRENT_IN] = direct,
+		.m[PSC_CURRENT_IN] = 9538,
+		.b[PSC_CURRENT_IN] = 0,
+		.R[PSC_CURRENT_IN] = -6,
+		.format[PSC_POWER] = direct,
+		.m[PSC_POWER] = 4901,
+		.b[PSC_POWER] = 0,
+		.R[PSC_POWER] = -7,
+		.func[0] = (PMBUS_HAVE_VIN |
+			    PMBUS_HAVE_VOUT |
+			    PMBUS_HAVE_VMON |
+			    PMBUS_HAVE_IIN |
+			    PMBUS_HAVE_PIN |
+			    PMBUS_HAVE_TEMP |
+			    PMBUS_HAVE_STATUS_VOUT |
+			    PMBUS_HAVE_STATUS_IOUT |
+			    PMBUS_HAVE_STATUS_INPUT |
+			    PMBUS_HAVE_STATUS_TEMP |
+			    PMBUS_HAVE_SAMPLES),
+		.read_word_data = tps25990_read_word_data,
+		.write_word_data = tps25990_write_word_data,
+		.read_byte_data = tps25990_read_byte_data,
+		.write_byte_data = tps25990_write_byte_data,
 
 #if IS_ENABLED(CONFIG_SENSORS_TPS25990_REGULATOR)
-	.reg_desc = tps25990_reg_desc,
-	.num_regulators = ARRAY_SIZE(tps25990_reg_desc),
+		.reg_desc = tps25990_reg_desc,
+		.num_regulators = ARRAY_SIZE(tps25990_reg_desc),
 #endif
+	},
 };
 
 static const struct i2c_device_id tps25990_i2c_id[] = {
-	{ .name = "tps25990" },
-	{ }
+	{ .name = "tps25990", .driver_data = tps25990 },
+	{}
 };
 MODULE_DEVICE_TABLE(i2c, tps25990_i2c_id);
 
 static const struct of_device_id tps25990_of_match[] = {
-	{ .compatible = "ti,tps25990" },
+	{ .compatible = "ti,tps25990", .data = (void *)tps25990 },
 	{}
 };
 MODULE_DEVICE_TABLE(of, tps25990_of_match);
@@ -401,8 +412,9 @@ MODULE_DEVICE_TABLE(of, tps25990_of_match);
 static int tps25990_probe(struct i2c_client *client)
 {
 	struct device *dev = &client->dev;
-	struct pmbus_driver_info *info;
+	struct tps25990_data *data;
 	const char *propname;
+	enum chips chip_id;
 	u32 rimon;
 	int ret;
 
@@ -415,15 +427,20 @@ static int tps25990_probe(struct i2c_client *client)
 		rimon = TPS25990_DEFAULT_RIMON;
 	}
 
-	info = devm_kmemdup(dev, &tps25990_base_info, sizeof(*info), GFP_KERNEL);
-	if (!info)
+	chip_id = (enum chips)(unsigned long)i2c_get_match_data(client);
+
+	data = devm_kzalloc(dev, sizeof(struct tps25990_data), GFP_KERNEL);
+	if (!data)
 		return -ENOMEM;
 
+	data->info = tps25990_base_info[chip_id];
+	data->chip_id = chip_id;
+
 	/* Adapt the current and power scale for each instance */
-	tps25990_set_m(&info->m[PSC_CURRENT_IN], rimon);
-	tps25990_set_m(&info->m[PSC_POWER], rimon);
+	tps25990_set_m(&data->info.m[PSC_CURRENT_IN], rimon);
+	tps25990_set_m(&data->info.m[PSC_POWER], rimon);
 
-	return pmbus_do_probe(client, info);
+	return pmbus_do_probe(client, &data->info);
 }
 
 static struct i2c_driver tps25990_driver = {
-- 
2.43.0