[PATCH v4 3/5] i2c: qcom-cci: Add 19.2 MHz timings for the v2 CCI

The v2 CCI (msm8996/sdm630/msm8953/...) is normally clocked at 37.5 MHz,
but its CCI clock can also be configured and run at 19.2 MHz. Add the
Standard and Fast timing sets calibrated for 19.2 MHz so that a v2
controller left at that rate still has valid timings for those modes
(Fast+ requires 37.5 MHz).

The values mirror the v1/v1.5 19.2 MHz Standard/Fast timings, which
share the same CCI clock rate.

Signed-off-by: Loic Poulain <[email protected]>
---
 drivers/i2c/busses/i2c-qcom-cci.c | 24 ++++++++++++++++++++++++
 1 file changed, 24 insertions(+)

diff --git a/drivers/i2c/busses/i2c-qcom-cci.c b/drivers/i2c/busses/i2c-qcom-cci.c
index 1092ce0371429ef64c7cc44cc23a42ba4c135af5..b6fa37a306758ec33ede6fcc39ce4412b86d9a84 100644
--- a/drivers/i2c/busses/i2c-qcom-cci.c
+++ b/drivers/i2c/busses/i2c-qcom-cci.c
@@ -762,6 +762,30 @@ static const struct cci_data cci_v2_data = {
 		.max_write_len = 11,
 		.max_read_len = 12,
 	},
+	.params[CCI_CLK_RATE_19_2MHZ][I2C_MODE_STANDARD] = {
+		.thigh = 78,
+		.tlow = 114,
+		.tsu_sto = 28,
+		.tsu_sta = 28,
+		.thd_dat = 10,
+		.thd_sta = 77,
+		.tbuf = 118,
+		.scl_stretch_en = 0,
+		.trdhld = 6,
+		.tsp = 1
+	},
+	.params[CCI_CLK_RATE_19_2MHZ][I2C_MODE_FAST] = {
+		.thigh = 20,
+		.tlow = 28,
+		.tsu_sto = 21,
+		.tsu_sta = 21,
+		.thd_dat = 13,
+		.thd_sta = 18,
+		.tbuf = 32,
+		.scl_stretch_en = 0,
+		.trdhld = 6,
+		.tsp = 3
+	},
 	.params[CCI_CLK_RATE_37_5MHZ][I2C_MODE_STANDARD] = {
 		.thigh = 201,
 		.tlow = 174,

-- 
2.34.1