[PATCH] ata: pata_pxa: use devres for DMA channel management

Convert the DMA channel request to devm_dma_request_chan() so the
channel is released automatically on device teardown. This removes
the explicit dma_release_channel() calls in the probe error paths
and in pxa_ata_remove(), simplifying the driver.

Devres releases in LIFO order, so the managed host detach registered
by ata_host_activate() runs before the DMA channel is released, which
preserves the previous teardown ordering.

Built as a module for arm/pxa_defconfig (CONFIG_PATA_PXA=m) with
LLVM=1 W=1; no new warnings.

Assisted-by: opencode:hy3-free
Signed-off-by: Rosen Penev <[email protected]>
---
 drivers/ata/pata_pxa.c | 13 +++----------
 1 file changed, 3 insertions(+), 10 deletions(-)

diff --git a/drivers/ata/pata_pxa.c b/drivers/ata/pata_pxa.c
index c816997dc0a9..a08b852dd9f9 100644
--- a/drivers/ata/pata_pxa.c
+++ b/drivers/ata/pata_pxa.c
@@ -262,33 +262,26 @@ static int pxa_ata_probe(struct platform_device *pdev)
 	/*
 	 * Request the DMA channel
 	 */
-	data->dma_chan = dma_request_chan(&pdev->dev, "data");
+	data->dma_chan = devm_dma_request_chan(&pdev->dev, "data");
 	if (IS_ERR(data->dma_chan))
 		return PTR_ERR(data->dma_chan);
+
 	ret = dmaengine_slave_config(data->dma_chan, &config);
 	if (ret < 0) {
 		dev_err(&pdev->dev, "dma configuration failed: %d\n", ret);
-		dma_release_channel(data->dma_chan);
 		return ret;
 	}
 
 	/*
 	 * Activate the ATA host
 	 */
-	ret = ata_host_activate(host, irq, ata_sff_interrupt,
+	return ata_host_activate(host, irq, ata_sff_interrupt,
 				pdata->irq_flags, &pxa_ata_sht);
-	if (ret)
-		dma_release_channel(data->dma_chan);
-
-	return ret;
 }
 
 static void pxa_ata_remove(struct platform_device *pdev)
 {
 	struct ata_host *host = platform_get_drvdata(pdev);
-	struct pata_pxa_data *data = host->ports[0]->private_data;
-
-	dma_release_channel(data->dma_chan);
 
 	ata_host_detach(host);
 }
-- 
2.55.0