[PATCH v8 0/5] iio: adc: Add support for LTC2378 and similar ADCs
Marcelo Schmitt <[email protected]>
| Newsgroups | org.kernel.vger.linux-iio,org.kernel.vger.linux-devicetree,org.kernel.vger.linux-kernel |
|---|---|
| Message-ID | <[email protected]> |
This patch series adds support for LTC2378 and similar low noise, low power, high speed, successive approximation register (SAR) ADCs. These ADCs are similar among each other, varying mainly on the amount of precision bits, maximum sample rate, and input configuration (either fully differential or pseudo-differential). Patch 1 adds device tree documentation for LTC2378. Patch 2 enables single-shot sample read with a GPIO connected to the LTC2378 CNV pin. Patch 3 enables high-speed data captures with SPI offloading. The setup is similar to AD4030, with a specialized PWM generator being used both for SPI offload triggering and conversion start signaling. Patch 4 enables running buffered data captures without SPI offloading. Patch 5 recommends using voltageY-voltageZ ABI for differential parts. Even though these parts are somewhat similar to AD4000, the wiring configuration for LTC parts is different as well as the available HDL for high speed sample rate mode. Because of that, I propose creating a new device driver for supporting LTC2378-like devices. Specifications can be found at: https://www.analog.com/media/en/technical-documentation/data-sheets/233818fa.pdf https://www.analog.com/media/en/technical-documentation/data-sheets/236416fa.pdf https://www.analog.com/media/en/technical-documentation/data-sheets/236418f.pdf https://www.analog.com/media/en/technical-documentation/data-sheets/236716fa.pdf https://www.analog.com/media/en/technical-documentation/data-sheets/236718f.pdf https://www.analog.com/media/en/technical-documentation/data-sheets/236816f.pdf https://www.analog.com/media/en/technical-documentation/data-sheets/236818f.pdf https://www.analog.com/media/en/technical-documentation/data-sheets/236918fa.pdf https://www.analog.com/media/en/technical-documentation/data-sheets/237016fa.pdf https://www.analog.com/media/en/technical-documentation/data-sheets/237616fa.pdf https://www.analog.com/media/en/technical-documentation/data-sheets/237618fa.pdf https://www.analog.com/media/en/technical-documentation/data-sheets/237620fb.pdf https://www.analog.com/media/en/technical-documentation/data-sheets/237716fa.pdf https://www.analog.com/media/en/technical-documentation/data-sheets/237718fa.pdf https://www.analog.com/media/en/technical-documentation/data-sheets/237720fb.pdf https://www.analog.com/media/en/technical-documentation/data-sheets/237816fa.pdf https://www.analog.com/media/en/technical-documentation/data-sheets/237818fa.pdf https://www.analog.com/media/en/technical-documentation/data-sheets/237820fb.pdf https://www.analog.com/media/en/technical-documentation/data-sheets/237918fb.pdf https://www.analog.com/media/en/technical-documentation/data-sheets/238016fb.pdf Previous submissions: v7: https://lore.kernel.org/linux-iio/[email protected]/ v6: https://lore.kernel.org/linux-iio/[email protected]/ v5: https://lore.kernel.org/linux-iio/[email protected]/ v4: https://lore.kernel.org/linux-iio/[email protected]/ v3: https://lore.kernel.org/linux-iio/[email protected]/ v2: https://lore.kernel.org/linux-iio/[email protected]/ v1: https://lore.kernel.org/linux-iio/[email protected]/ Change log v7 -> v8: [DT] No changes in device tree doc. [IIO] - Updated channel macros to make up indexed IIO channels. - Encourage differential voltage ABI usage [NEW PATCH]. - Simplified if/else to consecutive if statements on ltc2378_refin_setup(). - Picked up review tags. With best regards, Marcelo Marcelo Schmitt (5): dt-bindings: iio: adc: Add ltc2378 iio: adc: ltc2378: Add support for LTC2378-20 and similar ADCs iio: adc: ltc2378: Enable high-speed data capture iio: adc: ltc2378: Enable triggered buffer data capture iio: ABI: Encourage differential voltage ABI usage Documentation/ABI/testing/sysfs-bus-iio | 9 +- .../bindings/iio/adc/adi,ltc2378.yaml | 170 ++++ MAINTAINERS | 8 + drivers/iio/adc/Kconfig | 19 + drivers/iio/adc/Makefile | 1 + drivers/iio/adc/ltc2378.c | 851 ++++++++++++++++++ 6 files changed, 1054 insertions(+), 4 deletions(-) create mode 100644 Documentation/devicetree/bindings/iio/adc/adi,ltc2378.yaml create mode 100644 drivers/iio/adc/ltc2378.c base-commit: aa58ecc73466d0cb8c418de98e2225490bf600e3 -- 2.53.0