[PATCH 0/2] iio: adc: ti-ads112c14: continuous mode support

The TI ADS112C14 ADC has a continuous mode where it can trigger
conversions using its own clock and signals that data is ready using
the /DRDY line. This allows capturing data at higher rates since it
avoids the settling time between conversions. But it is limited to only
being able to sample one channel at a time.

Users will be able to select between continuous and single-shot mode
for buffered reads by selecting the trigger. If the "own" trigger from
the /DRDY interrupt is selected, continuous mode will be used. Or if
some other (software) trigger is selected, single-shot mode will be used
as was already implemented before this series.

Supporting open-drain /DRDY is deferred for future work. In simple cases
we have just done a `drive-open-drain` DT property for this, but on this
chip there is more than one pin (GPIO, FAULT interrupt) that could also
need to be open-drain and not all at the same time.

Signed-off-by: David Lechner (TI) <[email protected]>
---
David Lechner (TI) (2):
      iio: adc: ti-ads112c14: add DRDY interrupt support
      iio: adc: ti-ads112c14: add continuous mode support

 drivers/iio/adc/ti-ads112c14.c | 278 +++++++++++++++++++++++++++++++++++++----
 1 file changed, 251 insertions(+), 27 deletions(-)
---
base-commit: 0b5e142ced4bcf20532da051934bd694d1bbd470
change-id: 20260724-iio-adc-ti-ads112c14-continuous-mode-dd1580754609
prerequisite-change-id: 20260714-iio-adc-ti-ads112c14-buffered-read-41e5d1ca0dc3:v2
prerequisite-patch-id: 8723aa599dcf5b836fb81cf1efb6c9096bf60b7a
prerequisite-patch-id: 12754335ccf210bcdeaa8a5d60b2280618d50993

Best regards,
--  
David Lechner (TI) <[email protected]>