[PATCH v3 4/4] iio: accel: mma8452: Allow open drain interrupt pin configuration

When sharing interrupt line with other chips, the interrupt pin most
likely needs to be configured in open-drain mode instead of push-pull.

The PP_OD bit in CTRL_REG3 is set when open-drain mode is configured,
allowing sharing the interrupt line with other devices (with same interrupt
polarity).
The IRQF_SHARED flag is added to request_threaded_irq() flags, indicating
that the interrupt line can be shared with other devices.

Signed-off-by: Esben Haabendal <[email protected]>
---
 drivers/iio/accel/mma8452.c | 30 +++++++++++++++++++++++++++++-
 1 file changed, 29 insertions(+), 1 deletion(-)

diff --git a/drivers/iio/accel/mma8452.c b/drivers/iio/accel/mma8452.c
index 723ca3d9cb96..fa0915530f95 100644
--- a/drivers/iio/accel/mma8452.c
+++ b/drivers/iio/accel/mma8452.c
@@ -81,6 +81,8 @@
 #define  MMA8452_CTRL_REG2_RST			BIT(6)
 #define  MMA8452_CTRL_REG2_MODS_SHIFT		3
 #define  MMA8452_CTRL_REG2_MODS_MASK		0x1b
+#define MMA8452_CTRL_REG3			0x2c
+#define  MMA8452_CTRL_REG3_PP_OD		BIT(0)
 #define MMA8452_CTRL_REG4			0x2d
 #define MMA8452_CTRL_REG5			0x2e
 #define MMA8452_OFF_X				0x2f
@@ -119,6 +121,7 @@ struct mma8452_data {
 	int sleep_val;
 	u8 ctrl_reg1;
 	u8 data_cfg;
+	bool open_drain;
 };
 
  /**
@@ -647,6 +650,22 @@ static int mma8452_set_power_mode(struct mma8452_data *data, u8 mode)
 	return mma8452_change_config(data, MMA8452_CTRL_REG2, reg);
 }
 
+static int mma8452_set_interrupt_pin_mode(struct mma8452_data *data)
+{
+	int reg;
+
+	reg = i2c_smbus_read_byte_data(data->client, MMA8452_CTRL_REG3);
+	if (reg < 0)
+		return reg;
+
+	if (data->open_drain)
+		reg |= MMA8452_CTRL_REG3_PP_OD;
+	else
+		reg &= ~MMA8452_CTRL_REG3_PP_OD;
+
+	return i2c_smbus_write_byte_data(data->client, MMA8452_CTRL_REG3, reg);
+}
+
 /* returns >0 if in freefall mode, 0 if not or <0 if an error occurred */
 static int mma8452_freefall_mode_enabled(struct mma8452_data *data)
 {
@@ -1667,6 +1686,11 @@ static int mma8452_probe(struct i2c_client *client)
 			goto disable_regulators;
 	}
 
+	data->open_drain = device_property_read_bool(&client->dev, "drive-open-drain");
+	ret = mma8452_set_interrupt_pin_mode(data);
+	if (ret)
+		goto trigger_cleanup;
+
 	data->ctrl_reg1 = MMA8452_CTRL_ACTIVE |
 			  (MMA8452_CTRL_DR_DEFAULT << MMA8452_CTRL_DR_SHIFT);
 
@@ -1688,7 +1712,7 @@ static int mma8452_probe(struct i2c_client *client)
 		irq_flags = irq_get_trigger_type(client->irq);
 		if (irq_flags == IRQ_TYPE_NONE)
 			irq_flags = IRQF_TRIGGER_LOW;
-		irq_flags |= IRQF_ONESHOT;
+		irq_flags |= IRQF_ONESHOT | IRQF_SHARED;
 		ret = request_threaded_irq(client->irq, NULL, mma8452_interrupt,
 					   irq_flags, client->name, indio_dev);
 		if (ret)
@@ -1806,6 +1830,10 @@ static int mma8452_runtime_resume(struct device *dev)
 		return ret;
 	}
 
+	ret = mma8452_set_interrupt_pin_mode(data);
+	if (ret)
+		goto runtime_resume_failed;
+
 	ret = mma8452_active(data);
 	if (ret < 0)
 		goto runtime_resume_failed;

-- 
2.55.0