[PATCH v4 3/6] iio: accel: mma8452: Only apply trigger type when not set by firmware

Instead of unconditionally overriding the trigger type, it is better to
only apply a default when no trigger type is set by firmware. This should
be reasonably backward compatible, and should only potentially cause
problems if systems exist where firmware specifies an incorrect trigger
type. With a bit of luck, there are no such systems.

Reviewed-by: Andy Shevchenko <[email protected]>
Signed-off-by: Esben Haabendal <[email protected]>
---
 drivers/iio/accel/mma8452.c | 11 +++++++++--
 1 file changed, 9 insertions(+), 2 deletions(-)

diff --git a/drivers/iio/accel/mma8452.c b/drivers/iio/accel/mma8452.c
index f645a5c6fd1c..1fb43c5b0b72 100644
--- a/drivers/iio/accel/mma8452.c
+++ b/drivers/iio/accel/mma8452.c
@@ -1683,9 +1683,16 @@ static int mma8452_probe(struct i2c_client *client)
 		goto trigger_cleanup;
 
 	if (client->irq) {
+		unsigned long irq_flags;
+
+		irq_flags = irq_get_trigger_type(client->irq);
+		if (irq_flags == IRQ_TYPE_NONE) {
+			dev_info(dev, "invalid irq type, setting default active low\n");
+			irq_flags = IRQF_TRIGGER_LOW;
+		}
+		irq_flags |= IRQF_ONESHOT;
 		ret = request_threaded_irq(client->irq, NULL, mma8452_interrupt,
-					   IRQF_TRIGGER_LOW | IRQF_ONESHOT,
-					   client->name, indio_dev);
+					   irq_flags, client->name, indio_dev);
 		if (ret)
 			goto buffer_cleanup;
 	}

-- 
2.55.0