[PATCH v4 11/14] gpio: regmap: Use regmap_test_bits() for single bit reads

Use regmap_test_bits() when reading a single GPIO value from a normal
register and when reading the direction bit.

Reviewed-by: Linus Walleij <[email protected]>
Reviewed-by: Michael Walle <[email protected]>
Signed-off-by: Janani Sunil <[email protected]>
---
 drivers/gpio/gpio-regmap.c | 20 ++++++++++----------
 1 file changed, 10 insertions(+), 10 deletions(-)

diff --git a/drivers/gpio/gpio-regmap.c b/drivers/gpio/gpio-regmap.c
index 51b4d69b8740..0012e03d0d4e 100644
--- a/drivers/gpio/gpio-regmap.c
+++ b/drivers/gpio/gpio-regmap.c
@@ -83,11 +83,11 @@ static int gpio_regmap_get(struct gpio_chip *chip, unsigned int offset)
 	if (ret)
 		return ret;
 
+	if (gpio->reg_dat_base != gpio->reg_set_base)
+		return regmap_test_bits(gpio->regmap, reg, mask);
+
 	/* ensure we don't spoil any register cache with pin input values */
-	if (gpio->reg_dat_base == gpio->reg_set_base)
-		ret = regmap_read_bypassed(gpio->regmap, reg, &val);
-	else
-		ret = regmap_read(gpio->regmap, reg, &val);
+	ret = regmap_read_bypassed(gpio->regmap, reg, &val);
 	if (ret)
 		return ret;
 
@@ -157,7 +157,7 @@ static int gpio_regmap_get_direction(struct gpio_chip *chip,
 				     unsigned int offset)
 {
 	struct gpio_regmap *gpio = gpiochip_get_data(chip);
-	unsigned int base, val, reg, mask;
+	unsigned int base, reg, mask;
 	int invert, ret;
 
 	if (gpio_regmap_fixed_direction(gpio, offset)) {
@@ -186,14 +186,14 @@ static int gpio_regmap_get_direction(struct gpio_chip *chip,
 	if (ret)
 		return ret;
 
-	ret = regmap_read(gpio->regmap, reg, &val);
-	if (ret)
+	ret = regmap_test_bits(gpio->regmap, reg, mask);
+	if (ret < 0)
 		return ret;
 
-	if (!!(val & mask) ^ invert)
+	if (ret ^ invert)
 		return GPIO_LINE_DIRECTION_OUT;
-	else
-		return GPIO_LINE_DIRECTION_IN;
+
+	return GPIO_LINE_DIRECTION_IN;
 }
 
 static int gpio_regmap_try_direction_fixed(struct gpio_regmap *gpio,

-- 
2.43.0