Re: [PATCH v6 2/2] iio: adc: ti-ads112c04: Add support for TI ADS112C04

On Fri, Aug 21, 2026 at 6:59 PM Andy Shevchenko
<[email protected]> wrote:
>
> On Thu, Aug 20, 2026 at 03:51:52PM +0800, Kyle Hsieh wrote:
> > Add IIO driver support for the Texas Instruments ADS112C04 (16-bit)
> > delta-sigma ADCs.
> >
> > The driver implements:
> > - Single-shot conversions using the IIO raw read interface.
> > - Dynamic parsing of single-ended and differential channels from
> >   device tree child nodes.
> > - Hardware interrupt support via the DRDY pin, falling back to
> >   software polling if no IRQ is provided.
> > - Per-channel reference source selection (internal 2.048V, external
> >   REFP/REFN, or AVDD) via the reference-sources device tree property.
> >   refn-supply is not yet supported.
> > - Hardware reset via the reset controller framework, falling back to
> >   the RESET command when no reset controller is present.
>
> LGTM now,
> Reviewed-by: Andy Shevchenko <[email protected]>

Thanks!
>
> ...
>
> > +     /*
> > +      * Datasheet: td(RSSTA), the delay from the RESET rising edge to the
> > +      * first I2C START, is 100ns minimum.
>
> This is order of magnitude delay. Do you mean 100 盜? (Actually would be good to
> use Greek letter in the units, looks much cleaner in the comments.)
>
> > +      */
> > +     fsleep(1 * USEC_PER_MSEC);
>
> Otherwise this should be simply 1 (no multiplier).
The datasheet says 100ns minimum, so the comment was right but the delay
was far longer than needed. Changed to fsleep(1) and used µs in the
comment.

Thanks,
Kyle