[PATCH v2] HID: hid-oxp: fix UAF on pending work in remove()

oxp_cfg_probe() arms drvdata.oxp_mcu_init to run 50 ms after probe, and
oxp_mcu_init_fn() dereferences drvdata.hdev to issue MCU output reports
(hid_hw_output_report() followed by msleep(200)). The oxp_rgb_queue and
oxp_btn_queue workers are wired up the same way. oxp_hid_remove()
cancels all three with the non-synchronising cancel_delayed_work(), so a
worker already running is not waited for; removing the device while a
worker is asleep then frees the hid_device underneath it, leaving
drvdata.hdev stale -- a use-after-free when the worker wakes.

Use disable_delayed_work_sync() for all three in oxp_hid_remove(): it
drains a running worker and, unlike cancel_delayed_work_sync(), leaves
the works disabled so they cannot be re-armed by oxp_hid_raw_event_gen_2()
or oxp_rgb_brightness_set() while the device is torn down. Arm
oxp_mcu_init only after devm_device_add_group() succeeds in
oxp_cfg_probe(), so a probe failure can no longer leave it pending to
fire on the hid_device the caller tears down.

Fixes: 84910c459d65 ("HID: hid-oxp: Add OneXPlayer configuration driver")
Fixes: e4c850a6e750 ("HID: hid-oxp: Add Button Mapping Interface")
Fixes: 2f424f28fb39 ("HID: hid-oxp: Add Second Generation Gamepad Mode Switch")
Cc: [email protected]
Signed-off-by: Shengzhuo Wei <[email protected]>
---
Same delayed-work use-after-free class as the 7.2-rc6 sweep
(hid-lenovo-go, hid-lenovo-go-s, hid-lg-g15, hid-appleir, hid-letsketch);
hid-oxp was missed.
---
Changes in v2:
- Use disable_delayed_work_sync() instead of cancel_delayed_work_sync()
  so the works cannot be re-armed (e.g. via oxp_rgb_brightness_set())
  while the device is being torn down (Dmitry Torokhov).
- Arm oxp_mcu_init only after devm_device_add_group() succeeds, so a
  probe failure can no longer leave it pending to fire on a freed
  hid device (sashiko).
- Link to v1: https://lore.kernel.org/r/[email protected]
---
 drivers/hid/hid-oxp.c | 12 ++++++------
 1 file changed, 6 insertions(+), 6 deletions(-)

diff --git a/drivers/hid/hid-oxp.c b/drivers/hid/hid-oxp.c
index 20a54f337220dc2aee3483a14d542b66c487bd60..abd622ff1b26b312ad9c8a4375822832f8371533 100644
--- a/drivers/hid/hid-oxp.c
+++ b/drivers/hid/hid-oxp.c
@@ -1501,14 +1501,14 @@ static int oxp_cfg_probe(struct hid_device *hdev, u16 up)
 	drvdata.gamepad_mode = OXP_GP_MODE_XINPUT;
 	drvdata.rumble_intensity = 5;
 
-	INIT_DELAYED_WORK(&drvdata.oxp_mcu_init, oxp_mcu_init_fn);
-	mod_delayed_work(system_wq, &drvdata.oxp_mcu_init, msecs_to_jiffies(50));
-
 	ret = devm_device_add_group(&hdev->dev, &oxp_cfg_attrs_group);
 	if (ret)
 		return dev_err_probe(&hdev->dev, ret,
 				     "Failed to attach configuration attributes\n");
 
+	INIT_DELAYED_WORK(&drvdata.oxp_mcu_init, oxp_mcu_init_fn);
+	mod_delayed_work(system_wq, &drvdata.oxp_mcu_init, msecs_to_jiffies(50));
+
 	return 0;
 }
 
@@ -1552,9 +1552,9 @@ static int oxp_hid_probe(struct hid_device *hdev,
 
 static void oxp_hid_remove(struct hid_device *hdev)
 {
-	cancel_delayed_work(&drvdata.oxp_rgb_queue);
-	cancel_delayed_work(&drvdata.oxp_btn_queue);
-	cancel_delayed_work(&drvdata.oxp_mcu_init);
+	disable_delayed_work_sync(&drvdata.oxp_rgb_queue);
+	disable_delayed_work_sync(&drvdata.oxp_btn_queue);
+	disable_delayed_work_sync(&drvdata.oxp_mcu_init);
 	hid_hw_close(hdev);
 	hid_hw_stop(hdev);
 }

---
base-commit: 075b74841bd0065a3bda3440873c747938e69b68
change-id: 20260804-oxp-fix-879390c5e47f

Best regards,
-- 
Shengzhuo Wei <[email protected]>