[PATCH v5 03/14] kbuild: rename the strip_relocs command
Thomas Weißschuh <[email protected]>
| Newsgroups | org.kernel.vger.linux-integrity,org.kernel.vger.bpf,org.kernel.vger.linux-arch,org.kernel.vger.linux-doc,org.kernel.vger.linux-kbuild,org.kernel.vger.linux-kernel,org.kernel.vger.linux-modules,org.kernel.vger.linux-security-module,org.ozlabs.lists.linuxppc-dev |
|---|---|
| Message-ID | <[email protected]> |
This command is doing more than just stripping relocations. With the introduction of CONFIG_MODULE_HASHES it will do even more. Use a more generic name for the variable. Signed-off-by: Thomas Weißschuh <[email protected]> --- scripts/Makefile.vmlinux | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-) diff --git a/scripts/Makefile.vmlinux b/scripts/Makefile.vmlinux index fcae1e432d9a..6cc661e5292b 100644 --- a/scripts/Makefile.vmlinux +++ b/scripts/Makefile.vmlinux @@ -91,13 +91,13 @@ remove-symbols := -w --strip-unneeded-symbol='__mod_device_table__*' # To avoid warnings: "empty loadable segment detected at ..." from GNU objcopy, # it is necessary to remove the PT_LOAD flag from the segment. -quiet_cmd_strip_relocs = OBJCOPY $@ - cmd_strip_relocs = $(OBJCOPY) $(patsubst %,--set-section-flags %=noload,$(remove-section-y)) $< $@; \ - $(OBJCOPY) $(addprefix --remove-section=,$(remove-section-y)) $(remove-symbols) $@ +quiet_cmd_objcopy_vmlinux = OBJCOPY $@ + cmd_objcopy_vmlinux = $(OBJCOPY) $(patsubst %,--set-section-flags %=noload,$(remove-section-y)) $< $@; \ + $(OBJCOPY) $(addprefix --remove-section=,$(remove-section-y)) $(remove-symbols) $@ targets += vmlinux vmlinux: vmlinux.unstripped FORCE - $(call if_changed,strip_relocs) + $(call if_changed,objcopy_vmlinux) # modules.builtin.modinfo # --------------------------------------------------------------------------- -- 2.54.0