[PATCH] media: ipu-bridge: Add OV01A1B sensor config
Steve Kaznak <[email protected]>
| Newsgroups | org.kernel.vger.linux-kernel,org.kernel.vger.linux-media |
|---|---|
| Message-ID | <[email protected]> |
Add the Omnivision OV01A1B (ACPI HID OVTI01AB) to the
ipu_supported_sensors[] table, with the same single 400 MHz link
frequency as the OV01A10 and OV01A1S entries it shares a comment with.
The sensor is the IR camera in the Dell XPS 13 Plus 9320, behind an
Intel Vision Sensing Controller (IVSC). Commit 36eab90d3f4f ("media:
i2c: ov01a10: Add ov01a1b support") added driver support for it, but
without a bridge entry no fwnode graph endpoint is created, so the
driver never binds and the camera is not enumerated.
Tested on an XPS 13 Plus 9320: the sensor binds and streams 1296x816
Y10 at 30 fps.
Signed-off-by: Steve Kaznak <[email protected]>
---
drivers/media/pci/intel/ipu-bridge.c | 3 ++-
1 file changed, 2 insertions(+), 1 deletion(-)
diff --git a/drivers/media/pci/intel/ipu-bridge.c b/drivers/media/pci/intel/ipu-bridge.c
index 88581a4c081d..7a1e3cb30721 100644
--- a/drivers/media/pci/intel/ipu-bridge.c
+++ b/drivers/media/pci/intel/ipu-bridge.c
@@ -73,9 +73,10 @@ static const struct ipu_sensor_config ipu_supported_sensors[] = {
IPU_SENSOR_CONFIG("INT3537", 1, 437000000),
/* Lontium lt6911uxe */
IPU_SENSOR_CONFIG("INTC10C5", 0),
- /* Omnivision OV01A10 / OV01A1S */
+ /* Omnivision OV01A10 / OV01A1S / OV01A1B */
IPU_SENSOR_CONFIG("OVTI01A0", 1, 400000000),
IPU_SENSOR_CONFIG("OVTI01AS", 1, 400000000),
+ IPU_SENSOR_CONFIG("OVTI01AB", 1, 400000000),
/* Omnivision OV02C10 */
IPU_SENSOR_CONFIG("OVTI02C1", 1, 400000000),
/* Omnivision OV02E10 */
--
2.55.0