[PATCH net v4 5/6] net: phy: propagate errors from default port setup

From: Xuanqiang Luo <[email protected]>

phy_default_setup_single_port() ignores errors from phy_add_port() and
always reports success. If a PHY driver attach_mdi_port() callback fails,
the phy_port is leaked and PHY probing continues without the expected
default port.

Destroy the port and return the error.

Fixes: 589e934d2735 ("net: phy: Introduce PHY ports representation")
Reviewed-by: Andrew Lunn <[email protected]>
Signed-off-by: Xuanqiang Luo <[email protected]>
---
 drivers/net/phy/phy_device.c | 7 +++++--
 1 file changed, 5 insertions(+), 2 deletions(-)

diff --git a/drivers/net/phy/phy_device.c b/drivers/net/phy/phy_device.c
index 691396794decd..8cb0d60fcbba9 100644
--- a/drivers/net/phy/phy_device.c
+++ b/drivers/net/phy/phy_device.c
@@ -3483,6 +3483,7 @@ static int phy_default_setup_single_port(struct phy_device *phydev)
 {
 	struct phy_port *port = phy_port_alloc();
 	unsigned long mode;
+	int ret;
 
 	if (!port)
 		return -ENOMEM;
@@ -3509,9 +3510,11 @@ static int phy_default_setup_single_port(struct phy_device *phydev)
 		port->pairs = max_t(int, port->pairs,
 				    ethtool_linkmode_n_pairs(mode));
 
-	phy_add_port(phydev, port);
+	ret = phy_add_port(phydev, port);
+	if (ret)
+		phy_port_destroy(port);
 
-	return 0;
+	return ret;
 }
 
 static int of_phy_ports(struct phy_device *phydev)
-- 
2.43.0