module uhci-hcd and pm

Hello you all

The uhci-hcd module causes the cpu to work at highest frequecy
(according to x86info -mhz). If I unload it, cpu frequency dropps from full
(1.8GHz) to ~2/3 (1.1GHz). In both cases top shows 97% or even 99% idle.
modprobing it again speeds the cpu up again.

So module uhci-hcd prehibits the cpu clock from saving power on notebooks. (At 
least theese with P4-M cpus)

What code forces the cpu to run at high speed? Can I tweak the module to 
permit slower cpu speed?

Thomas Bettler

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.6 (GNU/Linux)

iD8DBQBBuehvePDD0plw9EYRAiNLAJ9oUnPfEkAfDRwkjZuUj3UPZq+JKQCgxyJk
Jbv6WGlItHQpxSz9fs9+IT8=
=0I7S
-----END PGP SIGNATURE-----