[PATCH v7 4/9] leds: st1202: set all pattern PWM slots to full after clearing pattern

pattern_clear() sets all PWM registers for the channel to LED_OFF (0).
In static mode (PATS=0), the LED output is ILED x Pattern0_PWM / 4095;
with Pattern0 at zero the LED remains dark regardless of the ILED value.

The LED1202 has a single global sequencer shared across all channels.
If another channel starts the sequencer after this one has been cleared,
the cleared channel runs through all 8 steps at zero duty cycle and
stays dark regardless of ILED.

Set all 8 PWM slots to ST1202_PATTERN_PWM_FULL so that ILED alone
controls the channel brightness in both static and sequencer modes.

Signed-off-by: Manuel Fombuena <[email protected]>
Assisted-by: Claude:claude-sonnet-4-6
---
 drivers/leds/leds-st1202.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/drivers/leds/leds-st1202.c b/drivers/leds/leds-st1202.c
index b4adade49898..3203b3768ec5 100644
--- a/drivers/leds/leds-st1202.c
+++ b/drivers/leds/leds-st1202.c
@@ -35,6 +35,7 @@
 #define ST1202_MILLIS_PATTERN_DUR_MIN      22
 #define ST1202_PATTERN_DUR                 0x16
 #define ST1202_PATTERN_PWM                 0x1E
+#define ST1202_PATTERN_PWM_FULL            0x0FFF
 #define ST1202_PATTERN_REP                 0x15
 
 struct st1202_led {
@@ -205,7 +206,7 @@ static int st1202_led_pattern_clear(struct led_classdev *ldev)
 		return ret;
 
 	for (int patt = 0; patt < ST1202_MAX_PATTERNS; patt++) {
-		ret = st1202_pwm_pattern_write(chip, led->led_num, patt, LED_OFF);
+		ret = st1202_pwm_pattern_write(chip, led->led_num, patt, ST1202_PATTERN_PWM_FULL);
 		if (ret != 0)
 			return ret;
 
-- 
2.55.0