Re: [PATCH net-next v4 5/5] ptp: ocp: Add Time Card V9 I2C peripheral topology

[email protected]
Newsgroups org.kernel.vger.linux-leds,org.kernel.vger.linux-devicetree
Message-ID <[email protected]> 
> Time Card V9 places a BME280 at 0x76, a BNO055 at 0x29, and an
> IS32FL3207 at 0x37 on PCA9546 channel 1.
> 
> Describe GNSS1 and GNSS2 as RGB LEDs on outputs 0 through 5 and SMA1
> through SMA4 on outputs 6 through 17. The board uses a 4.7 kohm RISET
> resistor, sequential red, green, and blue output wiring, and an 8100 uA
> per-output limit.
> 
> Select this profile only for the exact fixed-width EEPROM ID
> "TIMECARD-V9". Earlier revisions expose the same I2C devices with
> different LED routing, so probing cannot distinguish them safely. Leave
> erased, malformed, and unknown board IDs unconfigured.
> 
> Signed-off-by: Ahmad Byagowi <[email protected]>

Sashiko has reviewed this patch and found no issues. It looks great!

-- 
Sashiko AI review · https://sashiko.dev/#/patchset/[email protected]?part=5
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.