[PATCH v2 0/2] media: i2c: Add onsemi AR0234 camera sensor driver

This series adds a driver for the onsemi AR0234 CMOS image sensor.
The AR0234 is a 1/2.6-inch global-shutter sensor with a 1940x1220
pixel array, capable of 1920x1200 resolution at up to 120 fps.
It supports MIPI CSI-2 output with 1 to 4 data lanes, raw Bayer
(8/10-bit) and monochrome formats, as well as DPCM 10->8 compression.

The driver has been tested with 2 and 4 lanes on an ARM64 Rockchip
RK3588 platform with a 27 MHz external clock. Both 8-bit and 10-bit
raw Bayer modes are functional.

Notes:
- 1-lane mode is currently disabled; attempts to use it produced no
  valid image.

[root@diasom-evb ~]# v4l2-compliance -u 2
v4l2-compliance 1.28.1, 64 bits, 64-bit time_t

Compliance test for device /dev/v4l-subdev2:

Driver Info:
ar0234 9-0018: =================  START STATUS  =================
ar0234 9-0018: ==================  END STATUS  ==================
        Driver version   : 7.1.0
        Capabilities     : 0x00000000
        Client Capabilities: 0x0000000000000002
interval-uses-which
Required ioctls:
        test VIDIOC_SUDBEV_QUERYCAP: OK
        test invalid ioctls: OK

Allow for multiple opens:
        test second /dev/v4l-subdev2 open: OK
        test VIDIOC_SUBDEV_QUERYCAP: OK
        test for unlimited opens: OK

Debug ioctls:
        test VIDIOC_LOG_STATUS: OK (Not Supported)

Input ioctls:
        test VIDIOC_G/S_TUNER/ENUM_FREQ_BANDS: OK (Not Supported)
        test VIDIOC_G/S_FREQUENCY: OK (Not Supported)
        test VIDIOC_S_HW_FREQ_SEEK: OK (Not Supported)
        test VIDIOC_ENUMAUDIO: OK (Not Supported)
        test VIDIOC_G/S/ENUMINPUT: OK (Not Supported)
        test VIDIOC_G/S_AUDIO: OK (Not Supported)
        Inputs: 0 Audio Inputs: 0 Tuners: 0

Output ioctls:
        test VIDIOC_G/S_MODULATOR: OK (Not Supported)
        test VIDIOC_G/S_FREQUENCY: OK (Not Supported)
        test VIDIOC_ENUMAUDOUT: OK (Not Supported)
        test VIDIOC_G/S/ENUMOUTPUT: OK (Not Supported)
        test VIDIOC_G/S_AUDOUT: OK (Not Supported)
        Outputs: 0 Audio Outputs: 0 Modulators: 0

Input/Output configuration ioctls:
        test VIDIOC_ENUM/G/S/QUERY_STD: OK (Not Supported)
        test VIDIOC_ENUM/G/S/QUERY_DV_TIMINGS: OK (Not Supported)
        test VIDIOC_DV_TIMINGS_CAP: OK (Not Supported)
        test VIDIOC_G/S_EDID: OK (Not Supported)

Control ioctls:
        test VIDIOC_QUERY_EXT_CTRL/QUERYMENU: OK
        test VIDIOC_QUERYCTRL: OK
        test VIDIOC_G/S_CTRL: OK
        test VIDIOC_G/S/TRY_EXT_CTRLS: OK
        test VIDIOC_(UN)SUBSCRIBE_EVENT/DQEVENT: OK
        test VIDIOC_G/S_JPEGCOMP: OK (Not Supported)
        Standard Controls: 20 Private Controls: 0

Format ioctls:
        test VIDIOC_ENUM_FMT/FRAMESIZES/FRAMEINTERVALS: OK (Not Supported)
        test VIDIOC_G/S_PARM: OK (Not Supported)
        test VIDIOC_G_FBUF: OK (Not Supported)
        test VIDIOC_G_FMT: OK (Not Supported)
        test VIDIOC_TRY_FMT: OK (Not Supported)
        test VIDIOC_S_FMT: OK (Not Supported)
        test VIDIOC_G_SLICED_VBI_CAP: OK (Not Supported)
        test Cropping: OK (Not Supported)
        test Composing: OK (Not Supported)
        test Scaling: OK (Not Supported)

Codec ioctls:
        test VIDIOC_(TRY_)ENCODER_CMD: OK (Not Supported)
        test VIDIOC_G_ENC_INDEX: OK (Not Supported)
        test VIDIOC_(TRY_)DECODER_CMD: OK (Not Supported)

Buffer ioctls:
        test VIDIOC_REQBUFS/CREATE_BUFS/QUERYBUF: OK (Not Supported)
        test CREATE_BUFS maximum buffers: OK
        test VIDIOC_REMOVE_BUFS: OK
        test VIDIOC_EXPBUF: OK (Not Supported)
        test Requests: OK (Not Supported)

Total for device /dev/v4l-subdev2: 45, Succeeded: 45, Failed: 0, Warnings: 0

V1 -> V2:
- Fixed bugs reported by sashiko-bot:
  - [Low] The `compatible` property schema contains fatal YAML syntax errors due to missing list hyphens (`-`), resulting in invalid JSON schema constructs that will fail `dt_binding_check`.
  - [Low] The `data-lanes` schema constraint mathematically allows 3 lanes, which contradicts the explicit 2-or-4 lane hardware requirement described in the binding.
  - [Critical] Incorrect clamping order in crop selection bounds calculation causes unsigned integer underflow, bypassing bounds checks.
  - [High] Incorrect validation of `pm_runtime_get_if_active()` allows execution to proceed on negative error codes, leading to a usage counter underflow.
  - [High] Missing `v4l2_subdev_cleanup()` causes a memory leak of the subdevice active state.
  - [High] Static hblank lower bounds permit dynamic line length reduction below the absolute hardware minimum.
  - [High] Potential division by zero during delay calculation if the clock rate is zero.
  - [Medium] Unlocked V4L2 control helpers are called during initialization without acquiring the control handler lock, triggering a lockdep splat.
  - [Medium] Mixing goto-based error handling with scope-based `__free()` cleanup in the same function violates API guidelines.
  - [Medium] Changing the crop height fails to update exposure control limits reliably.
  - [Medium] The active format state is modified before verifying PLL configuration, leaving state inconsistent on error.
  - [Medium] Unlocked access to shared format state in `ar0234_get_frame_desc`.
  - [Low] Using `DIV_ROUND_UP` with a 64-bit numerator causes a link error on 32-bit architectures.

Alexander Shiyan (2):
  dt-bindings: media: i2c: Add onsemi AR0234 image sensor binding
  media: i2c: Add onsemi AR0234 image sensor driver

 .../bindings/media/i2c/onnn,ar0234.yaml       |  126 ++
 drivers/media/i2c/Kconfig                     |   12 +
 drivers/media/i2c/Makefile                    |    1 +
 drivers/media/i2c/ar0234.c                    | 1290 +++++++++++++++++
 4 files changed, 1429 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/media/i2c/onnn,ar0234.yaml
 create mode 100644 drivers/media/i2c/ar0234.c

-- 
2.52.0