Re: [PATCH v4 4/7] mmc: sdhci-esdhc-imx: disable irq during suspend to fix unhandled interrupt

On 03/07/2026 13:42, [email protected] wrote:
> From: Luke Wang <[email protected]>
> 
> When using WIFI out-of-band wakeup, an "irq xxx: nobody cared" warning
> occurs. This happens because the usdhc interrupt is not disabled during
> system suspend when device_may_wakeup() returns false.
> 
> The sequence of events leading to this issue:
> 1. System enters suspend without disabling usdhc interrupt
> (because device_may_wakeup() returns false for usdhc device)
> 2. WIFI out-of-band wakeup triggers system resume via GPIO interrupt
> 3. WIFI sends a Card interrupt before usdhc has fully resumed
> 4. usdhc is still in runtime suspend state and cannot handle the
> interrupt properly
> 5. The unhandled interrupt triggers "nobody cared" warning
> 
> Fix this by unconditionally disabling the usdhc interrupt during suspend
> and re-enabling it during resume, regardless of the wakeup capability.
> This ensures no interrupts are processed during the suspend/resume
> transition.
> 
> Fixes: 676a83855614 ("mmc: host: sdhci-esdhc-imx: refactor the system PM logic")
> Reviewed-by: Haibo Chen <[email protected]>
> Signed-off-by: Luke Wang <[email protected]>
> ---
>  drivers/mmc/host/sdhci-esdhc-imx.c | 11 ++++++-----
>  1 file changed, 6 insertions(+), 5 deletions(-)
> 
> diff --git a/drivers/mmc/host/sdhci-esdhc-imx.c b/drivers/mmc/host/sdhci-esdhc-imx.c
> index 3b1e63425a19..ade99dabdb5f 100644
> --- a/drivers/mmc/host/sdhci-esdhc-imx.c
> +++ b/drivers/mmc/host/sdhci-esdhc-imx.c
> @@ -2075,9 +2075,10 @@ static int sdhci_esdhc_suspend(struct device *dev)
>  	if (mmc_card_keep_power(host->mmc) && esdhc_is_usdhc(imx_data))
>  		sdhc_esdhc_tuning_save(host);
>  
> +	/* The irqs of imx are not shared. It is safe to disable */
> +	disable_irq(host->irq);

Pre-existing, but IRQ stays disabled even if there is an error later on

> +
>  	if (device_may_wakeup(dev)) {
> -		/* The irqs of imx are not shared. It is safe to disable */
> -		disable_irq(host->irq);
>  		ret = sdhci_enable_irq_wakeups(host);
>  		if (!ret)
>  			dev_warn(dev, "Failed to enable irq wakeup\n");
> @@ -2128,10 +2129,10 @@ static int sdhci_esdhc_resume(struct device *dev)
>  	/* re-initialize hw state in case it's lost in low power mode */
>  	sdhci_esdhc_imx_hwinit(host);
>  
> -	if (host->irq_wake_enabled) {
> +	if (host->irq_wake_enabled)
>  		sdhci_disable_irq_wakeups(host);
> -		enable_irq(host->irq);
> -	}
> +
> +	enable_irq(host->irq);

Is it OK to enable interrupts before sdhc_esdhc_tuning_restore()
and esdhc_set_dll_override() ?

>  
>  	/*
>  	 * restore the saved tuning delay value for the device which keep