Re: [PATCH v6 0/8] mmc: sdhci-esdhc-imx: fix SDIO suspend/resume issues

On 13/07/2026 07:38, [email protected] wrote:
> From: Luke Wang <[email protected]>
> 
> This series fixes several suspend/resume issues in the sdhci-esdhc-imx
> driver, primarily affecting SDIO devices (e.g., WiFi).
> 
> Issues fixed:
> - Tuning delay values not saved/restored for out-of-band wakeup devices
> - DLL override lost after resume for DDR modes
> - Pinctrl not restored before DDR_EN is set, causing CRC errors
> - Unhandled interrupt during resume causing "nobody cared" warning
> - Various error handling issues in suspend/resume paths
> 
> All patches now carry a Fixes tag pointing at v6.16. Patches 2-8 fix
> regressions introduced by commit 676a83855614 ("mmc: host:
> sdhci-esdhc-imx: refactor the system PM logic") in v6.16; patch 1 fixes
> commit c63d25cdc59a ("mmc: sdhci-esdhc-imx: Save tuning value when card
> stays powered in suspend"), also in v6.16.
> 
> Changes since v5:
> - Added Fixes tags to all remaining patches (patch 3, 6, 7, 8) so the
>   whole series is properly tagged for stable, as requested by Ulf.
>   No functional changes.
> 
> Changes since v4:
> - New patch 3: Fix esdhc_change_pinstate() to move IS_ERR checks for
>   pins_100mhz/pins_200mhz into their respective switch cases, so that
>   legacy timing modes can still reach pinctrl_select_default_state().
>   This avoids log spam on resume for devices without UHS pin states (Sashiko)
> 
> Changes since v3:
> - Patch 2: Remove unused 'boarddata' variable in esdhc_set_uhs_signaling()
> - Patch 7: Expand commit message to document intentional skip of enable_irq()
>   and sdhci_disable_irq_wakeups() on early return, and explain why the
>   PM runtime usage counter leak is acceptable (Sashiko)
> 
> Changes since v2:
> - Patch 3: Updated commit message to explain the SoC IP integration
>   detail about internal loopback path change when switching pinctrl
>   from GPIO to USDHC function (per Bough Chen suggestion)
> - Patch 5 (v2): Split into three separate patches (5/6/7) so each
>   patch fixes one problem (per Frank Li suggestion)
> 
> Changes since v1:
> - Added patch 5 to fix error handling issues identified during review
> - Use pm_runtime_resume_and_get() instead of pm_runtime_get_sync()
> - Make pinctrl and cd-wake failures non-fatal (dev_warn only)
> - Use esdhc_change_pinstate() instead of pinctrl_pm_select_default_state()
>   in resume to restore correct pin state based on timing mode
> - Skip pinctrl restore for wakeup devices to avoid SD bus glitch
> - Check pm_runtime_force_resume() return value in resume
> 
> Luke Wang (8):
>   mmc: sdhci-esdhc-imx: remove unnecessary mmc_card_wake_sdio_irq check
>     for tuning save/restore
>   mmc: sdhci-esdhc-imx: restore DLL override for DDR modes on resume
>   mmc: sdhci-esdhc-imx: fix esdhc_change_pinstate() to allow default
>     state restore
>   mmc: sdhci-esdhc-imx: restore pinctrl before restoring ios timing on
>     resume
>   mmc: sdhci-esdhc-imx: disable irq during suspend to fix unhandled
>     interrupt
>   mmc: sdhci-esdhc-imx: use pm_runtime_resume_and_get() in suspend
>   mmc: sdhci-esdhc-imx: make non-fatal errors non-blocking in suspend
>   mmc: sdhci-esdhc-imx: fix resume error handling
> 
>  drivers/mmc/host/sdhci-esdhc-imx.c | 84 ++++++++++++++++++++----------
>  1 file changed, 56 insertions(+), 28 deletions(-)
> 

Already acked patches 1 and 2, but now for all the rest:

Acked-by: Adrian Hunter <[email protected]>