[PATCH 1/2] mmc: via-sdmmc: stop card-detect handling on probe failure

request_irq() registers the SD card-detect interrupt and the probe enables
it before mmc_add_host() runs. If mmc_add_host() fails, the error path only
unmaps the registers and returns: the interrupt stays registered, so the
handler keeps running against the host once it is freed. via_sdc_isr()
dereferences sdhost and its MMIO base and schedules carddet_work, which
via_sdc_card_detect() also runs against freed memory through its
container_of() dereference.

Add a probe-error path that disables and frees the interrupt and cancels
carddet_work before unmapping. carddet_work can re-enable the device
interrupt via via_reset_pcictrl(), which restores PCIINTCTRL, so mask it
again after cancelling the work.

This issue was found by an in-house static analysis tool and confirmed by
manual code review.

Fixes: e4e46fb61e3b ("mmc: via-sdmmc: fix return value check of mmc_add_host()")
Cc: [email protected]
Assisted-by: Codex:gpt-5.6
Signed-off-by: Fan Wu <[email protected]>
---
 drivers/mmc/host/via-sdmmc.c | 8 +++++++-
 1 file changed, 7 insertions(+), 1 deletion(-)

diff --git a/drivers/mmc/host/via-sdmmc.c b/drivers/mmc/host/via-sdmmc.c
index c628b3bbfd7a..5228a1fe0495 100644
--- a/drivers/mmc/host/via-sdmmc.c
+++ b/drivers/mmc/host/via-sdmmc.c
@@ -1154,10 +1154,16 @@ static int via_sd_probe(struct pci_dev *pcidev,
 
 	ret = mmc_add_host(mmc);
 	if (ret)
-		goto unmap;
+		goto free_irq;
 
 	return 0;
 
+free_irq:
+	writeb(0x0, sdhost->pcictrl_mmiobase + VIA_CRDR_PCIINTCTRL);
+	free_irq(pcidev->irq, sdhost);
+	cancel_work_sync(&sdhost->carddet_work);
+	/* carddet_work may re-enable the interrupt via via_reset_pcictrl(). */
+	writeb(0x0, sdhost->pcictrl_mmiobase + VIA_CRDR_PCIINTCTRL);
 unmap:
 	iounmap(sdhost->mmiobase);
 release:
-- 
2.34.1