[PATCH v3 2/8] arm64: dts: agilex5: add SD/eMMC host controller

The Agilex5 HPS includes a Cadence SD6HC that drives either an SD card
or eMMC, depending on the SOCDK daughter card. It uses separate SDMCLK
(CIU) and L4_MP (BIU) clocks, and has three resets for the host
controller, Combo PHY, and SDMMC OCP bridge.

On the SOCDK OOBE card the slot is SD-only: fixed 3.3 V card supply and
a GPIO-selected 3.3 V / 1.8 V I/O supply for UHS-I signalling up to
SDR104.

Signed-off-by: Tanmay Kathpalia <[email protected]>
---
Depends on commit ab45ecfab540 ("dt-bindings: reset: altr: add
COMBOPHY_RESET for Agilex5"), which is already in mainline via the
reset tree. It is not yet in mmc/next; apply or merge that commit when
building/testing this patch on top of mmc/next.

 .../arm64/boot/dts/intel/socfpga_agilex5.dtsi | 25 ++++++++++++
 .../boot/dts/intel/socfpga_agilex5_socdk.dts  | 38 ++++++++++++++++++-
 2 files changed, 62 insertions(+), 1 deletion(-)

diff --git a/arch/arm64/boot/dts/intel/socfpga_agilex5.dtsi b/arch/arm64/boot/dts/intel/socfpga_agilex5.dtsi
index b06c6d5d60ee..5ccbd7bf2034 100644
--- a/arch/arm64/boot/dts/intel/socfpga_agilex5.dtsi
+++ b/arch/arm64/boot/dts/intel/socfpga_agilex5.dtsi
@@ -300,6 +300,31 @@ portb: gpio-controller@0 {
 			};
 		};
 
+		/*
+		 * Shared SD/eMMC controller node. On the SOCDK OOBE daughter-card
+		 * this is used for SD card operation; on the SOCDK eMMC daughter-card
+		 * it is configured for eMMC.
+		 */
+		emmc: mmc@10808000 {
+			compatible = "altr,agilex5-sd6hc", "cdns,sd6hc";
+			reg = <0x10808000 0x1000>;
+			/*
+			 * "ciu" (SDMCLK) is listed first so it is selected as the
+			 * primary clock by the SDHCI platform layer; the SD6HC PHY
+			 * timing calculations are derived from this clock rate.
+			 */
+			clocks = <&clkmgr AGILEX5_SDMCLK>, <&clkmgr AGILEX5_L4_MP_CLK>;
+			clock-names = "ciu", "biu";
+			dma-coherent;
+			interrupts = <GIC_SPI 96 IRQ_TYPE_LEVEL_HIGH>;
+			iommus = <&smmu 5>;
+			resets = <&rst SDMMC_RESET>, <&rst COMBOPHY_RESET>,
+				 <&rst SDMMC_OCP_RESET>;
+			reset-names = "sdhc-reset", "combophy", "sdmmc-ocp";
+
+			status = "disabled";
+		};
+
 		nand: nand-controller@10b80000 {
 			compatible = "cdns,hp-nfc";
 			reg = <0x10b80000 0x10000>,
diff --git a/arch/arm64/boot/dts/intel/socfpga_agilex5_socdk.dts b/arch/arm64/boot/dts/intel/socfpga_agilex5_socdk.dts
index 57d3c5807c65..f37038066922 100644
--- a/arch/arm64/boot/dts/intel/socfpga_agilex5_socdk.dts
+++ b/arch/arm64/boot/dts/intel/socfpga_agilex5_socdk.dts
@@ -36,9 +36,37 @@ memory@80000000 {
 		/* We expect the bootloader to fill in the reg */
 		reg = <0x0 0x80000000 0x0 0x0>;
 	};
+
+	vqmmc_io_reg: regulator-1p8v {
+		compatible = "regulator-gpio";
+		gpios = <&portb 3 GPIO_ACTIVE_HIGH>;
+		gpios-states = <0>;
+		regulator-max-microvolt = <3300000>;
+		regulator-min-microvolt = <1800000>;
+		regulator-name = "vqmmc-io";
+		states = <1800000 0x1>,
+			 <3300000 0x0>;
+	};
+
+	vmmc_reg: regulator-fixed-3p3v {
+		compatible = "regulator-fixed";
+		regulator-always-on;
+		regulator-max-microvolt = <3300000>;
+		regulator-min-microvolt = <3300000>;
+		regulator-name = "vcc-sd";
+	};
 };
 
-&gpio0 {
+&emmc {
+	bus-width = <4>;
+	cap-sd-highspeed;
+	disable-wp;
+	max-frequency = <200000000>;
+	no-mmc;
+	sd-uhs-sdr104;
+	vmmc-supply = <&vmmc_reg>;
+	vqmmc-supply = <&vqmmc_io_reg>;
+
 	status = "okay";
 };
 
@@ -59,6 +87,10 @@ emac2_phy0: ethernet-phy@0 {
 	};
 };
 
+&gpio0 {
+	status = "okay";
+};
+
 &gpio1 {
 	status = "okay";
 };
@@ -100,6 +132,10 @@ root: partition@4200000 {
 	};
 };
 
+&smmu {
+	status = "okay";
+};
+
 &uart0 {
 	status = "okay";
 };
-- 
2.43.7