Re: printing
Vedran Vucic <[email protected]>
| Newsgroups | org.kernel.vger.linux-msdos |
|---|---|
| Message-ID | <[email protected]> |
Hello, When I corrected as you mentioned dosemu started normally. I entered my DOS application and tried toprint, but in terminal I have seen error message that pcl6 command is not found. Any suggestion? Any link or slink needed for that purpose? Is there any path tweaking required? Best wishes, Vedran Vucic On Sat, Nov 27, 2010 at 5:10 PM, Frantisek Hanzlik <[email protected]> wrote: > Vedran Vucic wrote: >> Hello, >> >> When I applied what you suggested and compiled GhostPCL I got the >> following error message when I started dosemu: >> root:# dosemu >> In file included from built-in global.conf:122 >> from :122 >> Error in /etc/dosemu/dosemu.conf: (line 363) syntax error >> Error in /etc/dosemu/dosemu.conf: (line 363) unrecognized command 'sOutputFile' >> Error in /etc/dosemu/dosemu.conf: (line 363) unrecognized command >> '"|lpr -P Laserprinter"' >> 3 error(s) detected while parsing the configuration-file >> >> My global.conf is here: >> http://pastebin.ca/2003520 >> >> My dosemu.conf is here: >> >> http://pastebin.ca/2003522 > > Sorry, I yet noticed that You omit minus (-) sign at end of "$_lpt1=" > command ("-" sign mean, for pcl6 command, it must read its input from > stdin). All command line should be as: > > $_lpt1='pcl6 ... -sOutputFile="|lpr -P MyPrinter" -' > > (see attached full-length version) > > FH >