[PATCH] net: cpsw_new: unregister devlink on port registration failure

cpsw_probe() registers devlink before registering the CPSW ports.

If cpsw_register_ports() fails, the error path only unregisters the
notifiers and then releases the lower level resources. It does not undo
the successful cpsw_register_devlink() call, leaving the devlink instance
and its parameters registered after probe has failed.

Add a devlink cleanup label for the path where devlink registration has
already succeeded, and use it when port registration fails.

Fixes: ed3525eda4c4 ("net: ethernet: ti: introduce cpsw switchdev based driver part 1 - dual-emac")
Signed-off-by: Guangshuo Li <[email protected]>
---
 drivers/net/ethernet/ti/cpsw_new.c | 4 +++-
 1 file changed, 3 insertions(+), 1 deletion(-)

diff --git a/drivers/net/ethernet/ti/cpsw_new.c b/drivers/net/ethernet/ti/cpsw_new.c
index 7f42f58a4b03..95b3b58db6e0 100644
--- a/drivers/net/ethernet/ti/cpsw_new.c
+++ b/drivers/net/ethernet/ti/cpsw_new.c
@@ -2050,7 +2050,7 @@ static int cpsw_probe(struct platform_device *pdev)
 
 	ret = cpsw_register_ports(cpsw);
 	if (ret)
-		goto clean_unregister_notifiers;
+		goto clean_unregister_devlink;
 
 	dev_notice(dev, "initialized (regs %pa, pool size %d) hw_ver:%08X %d.%d (%d)\n",
 		   &ss_res->start, descs_pool_size,
@@ -2062,6 +2062,8 @@ static int cpsw_probe(struct platform_device *pdev)
 
 	return 0;
 
+clean_unregister_devlink:
+	cpsw_unregister_devlink(cpsw);
 clean_unregister_notifiers:
 	cpsw_unregister_notifiers(cpsw);
 clean_cpts:
-- 
2.43.0