Re: [PATCH v6 1/6] dt-bindings: gpio-mmio: Correct opencores GPIO

On Fri, Jan 23, 2026 at 10:18:04PM +0800, Gary Lau wrote:
> Hi Stafford,
> 
> I should clarify my setup: I'm using hardware address translation to make the
> OpenCores 8-bit GPIO appear as 32-bit to the CPU. Specifically:
> 
> 1. Address translation: The CPU's 32-bit addresses are right-shifted by 2 bits
>    (adr_i[2] in Verilog), so each 32-bit CPU access maps to the correct 8-bit
>    OpenCores register.
> 
> 2. Data width adaptation: Only dat_i[7:0] and dat_o[7:0] are connected, so
>    32-bit writes are truncated to 8-bit, and reads are zero-extended.
> 
> This hardware wrapper makes brcm,bcm6345-gpio driver "work" with my OpenCores
> GPIO, but it's really a hardware-level compatibility layer, not true software
> compatibility.
> 
> So you're absolutely right that the native opencores,gpio isn't compatible
> with brcm,bcm6345-gpio. My setup works because of custom hardware translation,
> not because the IP cores are compatible.

Thanks Gary for testing.

-Stafford