Re: [PATCH V3 13/14] i3c: mipi-i3c-hci: Factor out i3c_hci_sysdev()
Mukesh Savaliya <[email protected]> Wed, 5 Aug 2026 00:58:36 +0530
| Newsgroups | org.kernel.vger.linux-pci,org.infradead.lists.linux-i3c,org.kernel.vger.linux-kernel,org.kernel.vger.linux-pm |
|---|---|
| Message-ID | <[email protected]> |
Hi Adrian,
On 8/4/2026 7:08 PM, Adrian Hunter wrote:
[...]
> @@ -117,6 +118,17 @@ static inline struct i3c_hci *to_i3c_hci(struct i3c_master_controller *m)
> return container_of(m, struct i3c_hci, master);
> }
>
> +/*
> + * Determine the device that does PM / DMA and has IOMMU setup done for it in
> + * case of enabled IOMMU (for use with the DMA API).
> + * Such device is either "mipi-i3c-hci" platform device (OF/ACPI enumeration)
> + * parent or grandparent (PCI enumeration).
> + */
I was kind of confused and could not understand much (excuse me!). But
could draft below from function definition. I know comments removed from
below function and kept here.
Hope this can be simplified or improved further if possible.
/**
* i3c_hci_sysdev() - Get the device used for system PM and DMA
* operations
* @dev: HCI device
*
* Return the PCI parent device when the HCI controller is attached
* through PCI, otherwise return @dev itself. The returned device can
* be used for system power management and wakeup configuration.
*
* Return: Device to use for system PM and wakeup handling.
*/
> +struct device *i3c_hci_sysdev(struct device *dev)
> +{
> + return dev->parent && dev_is_pci(dev->parent) ? dev->parent : dev;
> +}
> +
> static void i3c_hci_set_master_dyn_addr(struct i3c_hci *hci)
> {
> reg_write(MASTER_DEVICE_ADDR,
> diff --git a/drivers/i3c/master/mipi-i3c-hci/dma.c b/drivers/i3c/master/mipi-i3c-hci/dma.c
> index 0672ed1132f8..7c2b20474130 100644
> --- a/drivers/i3c/master/mipi-i3c-hci/dma.c
> +++ b/drivers/i3c/master/mipi-i3c-hci/dma.c
> @@ -15,7 +15,6 @@
> #include <linux/errno.h>
> #include <linux/i3c/master.h>
> #include <linux/io.h>
> -#include <linux/pci.h>
>
> #include "hci.h"
> #include "cmd.h"
> @@ -301,23 +300,11 @@ static int hci_dma_init(struct i3c_hci *hci)
> {
> struct hci_rings_data *rings;
> struct hci_rh_data *rh;
> - struct device *sysdev;
> u32 regval;
> unsigned int i, nr_rings, xfers_sz, resps_sz;
> unsigned int ibi_status_ring_sz, ibi_data_ring_sz;
> int ret;
>
> - /*
> - * Set pointer to a physical device that does DMA and has IOMMU setup
> - * done for it in case of enabled IOMMU and use it with the DMA API.
> - * Here such device is either
> - * "mipi-i3c-hci" platform device (OF/ACPI enumeration) parent or
> - * grandparent (PCI enumeration).
> - */
> - sysdev = hci->master.dev.parent;
> - if (sysdev->parent && dev_is_pci(sysdev->parent))
> - sysdev = sysdev->parent;
> -
> regval = rhs_reg_read(CONTROL);
> nr_rings = FIELD_GET(MAX_HEADER_COUNT_CAP, regval);
> dev_dbg(&hci->master.dev, "%d DMA rings available\n", nr_rings);
> @@ -332,7 +319,7 @@ static int hci_dma_init(struct i3c_hci *hci)
> return -ENOMEM;
> hci->io_data = rings;
> rings->total = nr_rings;
> - rings->sysdev = sysdev;
> + rings->sysdev = i3c_hci_sysdev(hci->master.dev.parent);
>
> for (i = 0; i < rings->total; i++) {
> u32 offset = rhs_reg_read(RHn_OFFSET(i));
> diff --git a/drivers/i3c/master/mipi-i3c-hci/hci.h b/drivers/i3c/master/mipi-i3c-hci/hci.h
> index b3d9803b1968..b8d2a3d680f8 100644
> --- a/drivers/i3c/master/mipi-i3c-hci/hci.h
> +++ b/drivers/i3c/master/mipi-i3c-hci/hci.h
> @@ -184,6 +184,8 @@ void amd_set_resp_buf_thld(struct i3c_hci *hci);
> void i3c_hci_sync_irq_inactive(struct i3c_hci *hci);
> int i3c_hci_process_xfer(struct i3c_hci *hci, struct hci_xfer *xfer, int n);
>
> +struct device *i3c_hci_sysdev(struct device *dev);
> +
> #define DEFAULT_AUTOSUSPEND_DELAY_MS 1000
>
> int i3c_hci_rpm_suspend(struct device *dev);