Re: [PATCH v4 0/3] arm64: dts: qcom: eliza-evk: Enable PCIe0 and PCIe1 with M.2 and TC9563 switch

Bartosz Golaszewski <[email protected]>
Newsgroups org.kernel.vger.linux-pm,org.kernel.vger.linux-arm-msm,org.kernel.vger.linux-devicetree,org.kernel.vger.linux-kernel,org.kernel.vger.linux-pci
Message-ID <CAMRc=MdqPZbh2F37y0gqm=ZWSvXNO0Cv1A-jQPDe4jDnCHnyVg@mail.gmail.com>
On Tue, 28 Jul 2026 09:06:12 +0200, Krishna Chaitanya Chundru
<[email protected]> said:
> This series enables PCIe for the Eliza EVK board (CQS SoM on EVK carrier).
>
> The Eliza EVK exposes two PCIe ports:
>
> - PCIe0 drives an M.2 E key connector. The 3.3V supply is GPIO-controlled
>   via a TCA9538 I/O expander on I2C4. The slot hosts a WLAN module
>   (connected over PCIe) and a Bluetooth device (connected over UART5),
>   modelled with the pcie-m2-e-connector binding.
>
> - PCIe1 (8GT/s x2) connects to a Toshiba TC9563 PCIe switch, whose
>   management interface sits on I2C4 (address 0x77). The TC9563 RESX# and
>   PERST# lines are OR-ed internally; reset is driven via a TLMM GPIO on
>   the RESX# pin. The iommu-map covers all downstream switch ports
>   (SID range 0x1400-0x1408).
>
> The M.2 WLAN module carries a Qualcomm QCC2072 Bluetooth chip. A device-ID
> entry is added to the M.2 power sequencer so the serdev node for the BT
> UART interface is created on PCI enumeration.
>
> This seris Depends-on:
>   https://lore.kernel.org/all/[email protected]/
>   https://lore.kernel.org/all/20260630-dts-qcom-eliza-mtp-evk-add-pmics-v1-1-f4f320f7c88b@oss.qualcomm.com/
>
> Signed-off-by: Krishna Chaitanya Chundru <[email protected]>
> ---
> Changes in v4:
> - Added new line and used pcie port names as pcieN_portM (Konrad).
> - Link to v3: https://patch.msgid.link/[email protected]
>
> Changes in v3:
> - Clubbed pcie nodes to this series (Bjorn A)
>   (https://lore.kernel.org/all/[email protected]/)
> - Added comment for PERST (Mani).
> - Extended ranges property for pcie1 (Konrad).
> - Link to v2: https://patch.msgid.link/[email protected]
>
> Changes in v2:
> - Drop patch 3, as this is already applied
> - Rebase on top of https://lore.kernel.org/all/[email protected]/
>   and remove pincntrl as pincntrl is added in the eliza.dtsi patch and also remove
>   pinctrl for resx as this is covered in pcie1_default_state as perst gpio.
> - Link to v1: https://patch.msgid.link/[email protected]
>
> ---
> Krishna Chaitanya Chundru (3):
>       arm64: dts: qcom: eliza: Add PCIe PHY and controller nodes
>       arm64: dts: qcom: eliza-evk: Add PCIe0 with M.2 E key connector
>       arm64: dts: qcom: eliza-evk: Add PCIe1 with TC9563 PCIe switch
>
>  arch/arm64/boot/dts/qcom/eliza-evk.dtsi | 229 ++++++++++++++++++
>  arch/arm64/boot/dts/qcom/eliza.dtsi     | 415 +++++++++++++++++++++++++++++++-
>  2 files changed, 642 insertions(+), 2 deletions(-)
> ---
> base-commit: dc59e4fea9d83f03bad6bddf3fa2e52491777482
> change-id: 20260629-eliza_evk-6f30686b161f
> prerequisite-patch-id: 9e10dfbe360941cdac0300aaf163149755952f9f
> prerequisite-patch-id: fecce0170351baf00cbe8f6b302d1def4d99bbfc
> prerequisite-patch-id: 97cd6cb495fdd198f6de7fbe45ef32e4a638ec9c
> prerequisite-message-id: <20260630-dts-qcom-eliza-mtp-evk-add-pmics-v1-1-f4f320f7c88b@oss.qualcomm.com>
> prerequisite-patch-id: f3615b5c1e2222a2491f862a7fba3994058ecc53
>
> Best regards,
> --
> Krishna Chaitanya Chundru <[email protected]>
>
>

Reviewed-by: Bartosz Golaszewski <[email protected]>
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.